Nec VERSA TXI 6-CELL EXTENDED-LIFE BATTERY user Manual
NEC Versa TXi
6-Cell Extended-Life Battery
Congratulations on purchasing a 6-cell Extended-Life Battery (kit OP-570-74503) for your NEC
®
Versa
notebook computer! Install the Extended-Life Battery in the primary battery bay of the
computer, instead of the 3-cell primary battery that ships with your notebook computer. Like the
3-cell primary battery, the 6-cell Extended-Life Battery allows you to run your system when the
system is not plugged into a 120- or 240-volt, 50- or 60-Hz wall outlet. Use the 6-cell ExtendedLife Battery if you want to run your system on battery power for a longer time before you must
recharge the battery.
Before installing the battery be sure to read the information in this document about:
!
Features
!
Removing the Existing Primary Battery
!
Installing the 6-Cell Extended-Life Battery
!
Removing the 6-Cell Extended-Life Battery
!
Charging the Battery
!
Determining Battery Status
!
General Battery Precautions
!
Battery Disposal
!
Battery Specifications
To prevent accidental battery ignition or explosion, adhere to the
following:
Keep the battery away from extreme heat.
!
Keep metal objects away from the battery connector to prevent a short circuit.
!
Make sure the battery is properly installed in the battery bay.
!
Do not alter or disassemble the battery.
!
Read any precautions printed on the battery.
!
Keep the following in mind when removing or replacing a battery.
!
Use only the battery designed for your system in your NEC Versa notebook computer.
Mixing other manufacturers’ batteries, or using a combination of very old and new batteries
can deteriorate battery and equipment performance.
!
Clean the battery connector with a dry cloth when it gets dirty.
!
Keep the battery out of the reach of children.
NEC Versa TXi 6-Cell Extended-Life Battery 1
Features
The NEC Versa Extended-Life Battery is used as the main source of power when your system is
not plugged into an AC power source. See the following figure for Extended-Life Battery
features.
The Extended-Life Battery
A – Alignment Grooves B – Connector
Removing the Existing Primary Battery
Use the following steps to remove the existing primary battery from the system.
1.
Save your files, exit the Microsoft® Windows® operating system, turn off system power,
and unplug the system.
2.
Close the LCD panel and turn the system over.
3.
Slide the battery release latch toward the right side of the system and hold firmly.
Locating the battery release latch
A – Existing Primary Battery B – Battery Release Latch
2 NEC Versa TXi 6-Cell Extended-Life Battery
Loading...