Safety Camera POIs ..................................................................49
POI categories .........................................................................50
Branded POIs ..........................................................................52
POI categories by subscription .............................................52
My Places categories ..........................................................52
3
Important safety information
Removing original equipment, adding accessories or modifying your vehicle could affect
the vehicle’s safety or make it illegal to operate in some jurisdictions.
Follow all product instructions and all instructions in your vehicle owner’s manual
regarding accessories or modifications.
Consult your country’s and/or state’s laws regarding operation of a vehicle with any
accessories or modifications.
It is your sole responsibility to place, secure and use your Navman in a manner that will
not cause accidents, personal injury or property damage. Always observe safe driving
practices.
Do not mount your Navman in a way that may interfere with the safe operation of the
vehicle, the deployment of air bags or other safety equipment.
Do not operate your Navman while driving.
Before you use your Navman for the first time, familiarize yourself with your device and
its operation.
On main roads, the distance to an exit calculated by your Navman may be further than
the distance shown on road signs. Road signs show the distance to the start of an exit
while your Navman shows the distance to the next intersection, i.e., the end of the exit
ramp or road. To prepare to exit a road, always follow distance information on road
signs.
The use of information regarding safety or speed camera locations may be subject to
local laws in the country of use. You are responsible for checking that you can legally use
the information in your country or in the country where the information will be used.
Do not handle your Navman while it is hot. Let the product cool, out of direct sunlight.
Precautions
Failure to adhere to these warnings and cautions may lead to death, serious injury or
property damage. Navman disclaims all liability for installation or use of your Navman that
causes or contributes to death, injury or property damage or that violates any law.
About charging
Use only the charger supplied with your device. Use of another type of charger will
result in malfunction and/or danger.
This product is intended to be supplied by a LISTED Power Unit marked with “LPS,”
“Limited Power Source” and output rated + 5 V dc / 1.5 A.
Use a specified battery in the equipment.
4
About the charger
Do not use the charger in a high moisture environment. Never touch the charger when
your hands or feet are wet.
Allow adequate ventilation around the charger when using it to operate the device or
charge the battery. Do not cover the charger with paper or other objects that will reduce
cooling. Do not use the charger while it is inside a carrying case.
Connect the charger to a proper power source. The voltage requirements are found on
the product case and/or packaging.
Do not use the charger if the cord becomes damaged.
Do not attempt to service the unit. There are no serviceable parts inside. Replace the
unit if it is damaged or exposed to excess moisture.
About the battery
Use a specified battery in the equipment.
CAUTION: The battery can burst or explode, releasing hazardous chemicals. To reduce
the risk of fire or burns, do not disassemble, crush, puncture, or dispose of in fire or
water.
Important instructions (for service personnel only)
Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
Replace only with the same or equivalent type recommended by the manufacturer.
The battery must be recycled or disposed of properly.
Use the battery only in the specified equipment.
Only use the correct home charger (may be sold separately) or in-car charger supplied
by Navman to charge your Navman internal battery.
Only use your Navman internal battery with your Navman unit.
The Navman battery will stop charging when the ambient temperature is less than 0°C
(32°F) or more than 40°C (104°F).
Declaration of conformity
Marking labels located on the exterior of your Navman indicate the regulations that
your model complies with. Please check the marking labels on your Navman and refer
to the corresponding statements in this chapter. Some notices apply to specific models
only.
The user needs to switch off the Navman when exposed to areas with potentially explosive
atmospheres such as petrol stations, chemical storage depots and blasting operations.
5
WEEE
This product must not be disposed of as normal household waste, in accordance with the
EU directive for waste electrical and electronic equipment (WEEE - 2002/96/EC). Instead,
it should be disposed of by returning it to the point of sale, or to a municipal recycling
collection point.
6
Getting to know your Navman
NameDescription
❶
Power buttonTurns your Navman on and off.
❷
Reset buttonRestarts your Navman.
❸
SpeakerSends out sounds and voice.
❹
StylusTap on the touch screen to make selections and enter information.
❺
Status indicatorGlows in green when charging is in progress.
❻
Touch screenDisplays the output of your Navman. Tap the screen with your fingertip
to select menu commands or enter information.
❼
MicrophoneReceives sound and voice.
❽
Earphone jackConnects a set of earphones.
❾
Memory card slotAccepts a MicroSD card for accessing data such as maps.
❿
Mini-USB connector Connects to the charger or USB cable.
7
Mounting your Navman in a vehicle
CAUTION:
•Never mount your Navman where the driver’s field of vision is blocked.
•If the windscreen is tinted with a reflective coating, it may be athermic and impact the GPS
reception. In this instance, please mount your Navman where there is a “clear area” - usually
just beneath the rear-view mirror.
•To protect your Navman against sudden surges in current, connect the in-car charger only after
the car engine has been started.
When you unplug the external power source, the device will automatically enter a
suspended state within 10 seconds. To continue using the device, tap Yes.
8
Turning your Navman ON and OFF
Note: The battery may not be fully charged when you use your device for the first time.
For the initial start-up, press and hold the power button until the device turns on.
When you turn on your device for the first time, follow the prompts to customise your
device.
Note: The first time you use your Navman, it may take several minutes to establish a GPS
connection. When you have a GPS fix, you can start to use your Navman to plan your trip.
While the device is turned ON, press the power button and it will enter a suspended
state.
To resume using the device, do one of the following:
Press the power button briefly.
Connect the device to an external power source.
To turn OFF the device, press and hold the power button until the device shuts down.
CAUTION: For optimal performance of the lithium battery:
•Do not charge the battery where the temperature is high (e.g. in direct sunlight).
•There is no need to fully discharge the battery before charging. You can charge the battery
before it is discharged.
•When storing the product for a long period of time, be sure to fully charge the battery at least
once every two weeks. Over discharge of the battery can affect the charging performance.
•Failure to follow the battery usage instructions could cause damage to your device, battery and
even bodily injury or property damage and will void any warranty.
CAUTION: When your Navman is turned on and connected to a computer, it is recognised as
an external mass-storage device. Do NOT delete any files that are pre-installed on your Navman.
Deleting the files can cause your Navman to crash.
Resetting your Navman
Occasionally, you may need to perform a hardware reset when your Navman stops
responding, or appears to be “frozen” or “locked-up.”
Insert a small rod, such as a straightened paperclip (or the stylus), into the reset button of
your Navman. Your Navman will restart automatically.
9
Navigating on the screen
To operate your Navman, touch the screen with your fingertip (or the stylus). You can
perform the following actions:
Tap
Press and release an item displayed on the touch screen.
Select
Tap an item on a list or tap a command from a menu.
Inserting a memory card
CAUTION: Do not apply pressure to the centre of the memory card.
Hold the card (MicroSD) by the edges and gently insert it into the slot as shown below.
To remove a card, gently push the top edge of the card inwards to release it, and pull it out
of the slot. Inserting the card in the reverse direction may cause damage.
Note: Navman does not guarantee the product’s compatibilities with MicroSD cards from all
manufacturers.
10
Main Menu
The Main Menu is your starting point for searching for a destination. The Main Menu also
allows you to customise your Navman, view saved locations as My Place/Home, and search
for POIs nearby, and so on.
Tap to show the next page of Main Menu.
Note: Main Menu screen options and the order of the options may differ from the above, depending
on your region, maps installed or Navman model.
IconDescription
Search for places, areas and streets to help plan your route.
Display the Map screen.
Access your saved locations.
Configure your Navman to enhance your navigation experience.
Search for POIs nearby.
11
Navigating through the menu screens
The system provides the BACK button ( ) and MAIN MENU button ( ) in the title
bar of the menu screen which allow you to navigate through the menu screens easily. You
can:
Return to the previous screen by tapping the BACK button.
Return to the Main Menu by tapping the MAIN MENU button.
Note: In some menu screens, the MAIN MENU button will not appear in the title bar. In this instance,
you may have to tap the BACK button twice.
In some menu screens (such as the map Overview screen), the system provides the tab
buttons in the title bar that allow you to enter the additional page in the menu screen.
Simply tap the desired tab to change the view. The selected tab will be highlighted as a
darker-colour tab.
12
Using the Keyboard screen
The Keyboard screen will display when you are required to enter text, such as when
searching for a street name.
The Keyboard screen can display with various layouts depending on the information you
need to enter, including alphabets, numbers, alternate characters and combinations of
these.
To select a character, tap the character.
To delete a character, tap
. Tap and hold to delete the entire text.
To enter numbers, tap
To set the keyboard preference from the Keyboard screen, tap
preferred keyboard type from the list.
.
. Select the
13
How do I go from A-B?
CAUTION: For your safety, enter destination information before you start a journey. Do not enter
a destination while driving.
How do I use the FIND wizard?
Your Navman is equipped with maps that provide street-level details for door-to-door
navigation, including POIs such as accommodation, parking areas, petrol stations, railway
stations and airports. The FIND wizard allows you to search the location easily.
1. On the Main Menu, tap
Note: FIND screen display and the order of the options may differ from the below, depending on
your region, maps installed or model of Navman.
to display the FIND screen.
2. Complete the following:
If you want to…Then…
search all information on the device - city, streets, named sites, features,
landmarks or venues,
search for an address,
search for a city/area,
search for a location from the Map screen (EZY series only),
search a location by postcode,
search for a POI,
tap
tap
tap
tap
tap
tap
.
.
.
.
.
.
Note: For further instructions on searching for a POI, refer to the “How do I search for a POI?”
section.
14
How do I plan my first trip?
Note: Menu displays may vary, depending on your Navman model.
Using your Navman to plan your first trip is easy. There are several ways to select your
destination. The following steps will show you how to plan your route by searching the
address.
Complete the following:
If you want to…Then…
calculate the route and start navigating,
save the location as a favourite,
save the location as Home,
explore the map,
tap
tap
tap
tap
.
.
. Then tap .
.
15
How do I preview the destination on map?
After searching an address (or a POI), you can preview the destination on map to explore
the area near the location.
1. On the Destination screen, tap the
2. On the destination preview map, you can:
Tap the
View the information of your destination that is shown at the top of the Map screen.
Tap on a street/area/POI to display the related information of the location near your
destination.
/ button to zoom in/out the map.
button to display the destination preview map.
Tap the grey arrow icon (
Drag and then tap on the map to select other destinations. The information of the
selected street/area/POI near your destination will be displayed. Tapping the check
mark will bring up the Destination screen of the selected location.
) to return to your current position on the map.
16
Loading...
+ 37 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.