Mitsubishi 3DA-1 owners Manual
3D Adapter
MODEL
3DA-1
OWNER’S GUIDE
Features
Converts 3D video originating in several popular formats to checker-•
board format for display on your 3D or 3D-ready Mitsubishi television.
Processes side-by-side, top-and-bottom, and frame-packing 3D •
(e.g., Blu-ray 3D) formats.
Passes 2D images unaltered for normal display.•
Compatible with these Mitsubishi television models:
3D-Ready
Televisi o n s
(2007 through
2010)
3D Televisions
(starting in 2010)
833 series (2007) L65-A90 (2008) L75-A91 (2010)
C8 series (2008) 737 series (2009) 638 series (2010)
735 series (2008) 837 series (2009) C10 series (2010)
736 series (2008) C9 series (2009)
835 series (2008) L75-A81 (2010)
738 series (2010) 838 series (2010)
2
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
8) Only use attachments/accessories specified by the manufacturer.
Refer all servicing to qualified service personnel. Servicing is
9)
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been exposed
to rain or moisture, does not operate normally, or has been dropped.
FCC Information
Product: 3D Adapter
Model: 3DA-1
Responsible
Party:
NOTE: This equipment has been
tested and found to comply with
the limits for a Class B digital
device, pursuant to Part 15 of
the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses
and can radiate radio frequency
energy and, if not installed and
used in accordance with the
instructions, may cause harmful
interference to radio communi-
Mitsubishi Digital
Electronics
America, Inc.
9351 Jeronimo Rd.
Irvine, CA
92618-1904
cations. However, there is no
guarantee that interference will not
occur in a particular installation.
If this equipment does cause
harmful interference to radio or
television reception, which can
be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
Reorient or relocate the •
receiving antenna.
Increase the separation •
between the equipment and
receiver.
Connect the equipment into •
an outlet on a circuit different
from that to which the receiver
is connected.
Consult the dealer or an expe-•
rienced radio/TV technician
for help.
WARNING. To reduce the risk of fire or electric shock, do not expose this
apparatus to rain or moisture.
Please check www.mitsubishi-tv.com for updates on 3D signals and safety.
3
Battery Installation
The remote control requires one CR2025 lithium battery.
1
To remove the
battery, press
Emitter
2
on the retain-
ing clip.
Remove the cover.1.
Insert the battery, positive side up. Be sure the retain-2.
ing clip holds the battery securely.
Reinstall the cover.3.
Lithium Battery Safety
This product uses a CR2025 Li/MnO2 lithium coin battery.
WARNING: Lithium coin cell batteries pose a serious risk of injury if
ingested. Keep cells out of reach of children. If ingested immediately
contact a physician or the National Poison Center at 202-625-3333.
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type (CR2025).
CAUTION: Risk of fire and burns. Do not recharge, disassemble,
heat above 100
children.
Disposal. Dispose of used batteries promptly according to local
recycling or waste regulations.
C (212˚ F), or incinerate. Keep battery out of reach of
˚
Controls and Indicators
POWER
3D STATUS
IR Sensor
POWER
Light Lit when power is on.
3D STATUS
POWER
3D MODE
Light Lit during 3D signal processing.
Button
Allows manual override of auto on/off. Press to power
off the Adapter if it powers on when not needed,
Button Allows manual selection of 3D format conversion.
For assistance call 1(800) 332-2119
POWER
3D MODE
Adapter
POWER
3D MODE
Remote Control
Loading...