Miele WTV 405 INSTALLATION MANUAL
WTV 405 Stacking Kit Installation Instructions
W1113 Washer and T1302, 1303,1322C, 1323C Dryers
Stacking Kit Shelf Removal (Fig. 1)
Warning!
Prior to installation or service disconnect the units by “tripping” the breaker,
unplugging the unit or removing the fuse.
Installation and service should be by a Miele authorized service technician.
Work by unqualified persons could be hazardous and may void the warranty.
• Push the self in slightly to
release.
• Pull the shelf out until it stops.
• Lift the shelf slightly; pull forward
and tilt downward to remove.
Washer Lid Removal (Fig. 2)
• Remove the 2 screw caps (a)
• Loosen the lid screws 5 turns. (b)
• Push lightly on the screws to release
the retaining clips.
• Lift the front of the lid and slide it
backwards to remove.
• Remove the 2 screws from the rear lid
brackets (c)
• Slide the brackets to the side and
remove.
Fig.2
b
c
c
a
a
Fig.1
Installing the Stacking Kit (Fig.3)
After removing the washer lid, lay the
stacking into position on top of the
washer.
• Secure the stacking kit with the
screws provided.
o 2 screws with star washers in
the rear (a)
o 4 screws without star washers
on top.
Dryer Installation (Fig. 4)
• Adjust the dryer feet to ¾”
as shown. (a)
• Make sure the flat side of
foot pad faces forward. (a)
• Place the dry in the guides
of the stacking kit and slide
back into position.
• Install the retaining brackets and secure
with the provided screws. (b)
• Reinstall the shelf.
a
Note
¾”
a
Use caution when lifting heavy objects
Fig. 4
Fig.3
b
Loading...