In order to protect yourself and
avoid damage to your machine,
it is absolutely necessary to read
the operating instructions prior
to installation and operation.M.-Nr. 05 226 210
1 Supply cable
2 High pressure inlet hoses
3 Flexible drain hose, with detachable
swivel elbow
4 Detergent dispenser drawer
5 Control panel
6 Drum door
7 Panel for access to lint filter and drain
pump
8 Four height adjustable feet
3
Guide to the machine
Detergent dispenser drawer
Compartment i - for the pre-wash.
Compartment j - for the main wash.
b “Delay start” button.
c Time display “h mins”.
Compartment
softener or starch.
p (with lid) - for fabric
f Pushbuttons for additional functions.
g SPIN SPEED SETTING switch.
d “Door” button;
opens the drum door.
e “ON/OFF” button;
to turn machine on or off or
to interrupt a programme.
The “On” lamp illuminates.
4
h PROGRAMME SEQUENCE indica-
tors (LED indicator lamps).
i Programme SELECTOR switch.
Important safety instructions
Important safety instructions
WARNING – To reduce the risk of
fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the
following:
1. Read all instructions before using
the appliance.
2. Do not wash articles that have
been previously cleaned in,
washed in or soaked in gasoline,
dry-cleaning solvents, or other
flammable or explosive substances. They give off vapors that
could ignite or explode.
3. Do not allow children to play on or
in the appliance. Close supervision is necessary when the appliance is used near children.
4. Before the appliance is removed
from service or discarded, remove
the door to the washing compartment.
9. Do not add gasoline, dry-cleaning
solvents, or other flammable or explosive substances to the wash
water. These substances give off
vapors that could ignite or explode.
10. Under certain conditions, hy-
drogen gas may be produced in a
hot water system that has not
been used for 2 weeks or more.
HYDROGEN GAS IS EXPLOSIVE.
If the hot water system has not
been used for such a period, before using the washing machine,
turn on all hot water faucets and
let the water flow from each for
several minutes. This will release
any accumulated hydrogen gas.
As the gas is flammable, do not
smoke or use an open flame during this time.
SAVE THESE INSTRUCTIONS
5. Do not reach into the appliance if
the drum is moving.
6. Do not install or store this ap-
pliance where it will be exposed
to weather.
7. Do not tamper with the controls.
8. Do not repair or replace any part of
the appliance, or attempt any servicing unless specifically recommended in the user-maintenance
instructions or in published userrepair instructions that you understand and have the skills to carry
out.
Refer to the Electrical Connection Section for grounding and installation instructions.
5
Help protect our environment
Help protect our environment
Warning - To reduce the risk of fire,
electric shock, or injury to persons,
read the IMPORTANT SAFETY INSTRUCTIONS before operating this
appliance.
Disposal of the packing
material
The transport and protective packing is
mostly manufactured from the following
recycled or recyclable materials:
– corrugated paper/cardboard
– polystyrene - CFC-free
– polystyrene foil (transparent)
– Untreated wood
– Polypropylene (PP) strapping
Rather than throwing these materials
away, please take them to your community recycling center.
Disposal of your old machine
Old machines contain materials which
can be recycled. Please contact your
recycling center or scrap merchant before disposing of the appliance.
6
Economical usage
The key to good wash results is finding
the correct combination of detergent
and temperature, and then allowing the
washing machine to optimize their
usage through its programming. Programme lengths can vary for this reason.
With the “Hydromatic” system, the
drum can revolve at various speeds.
Faster and slower agitation speeds,
along with pauses for soaking, combine to ensure excellent results.
The automatic load control feature ensures the correct water level for the
type of fabric and load being washed
(even though it may appear as if there
is too little water in the drum!).
Because of the accurately balanced
drum and special sound insulation, machine noise is minimal while operating.
The fully electronic controls offer a combination of simple operation with many
optional features.
Economical usage
Economy
For optimum economical usage, remember the following tips:
– The automatic load control feature
will adjust the water level for loads
between 1 and 5 kg. However, if
possible, load the machine to its
maximum capacity in order to use
water and energy to the best advantage.
– Use only the correct amount of deter-
gent required for the water hardness
in your area. Miele recommends the
use of low-sudsing detergents, as
their characteristics allow them to
perform better in front-loading machine than regular powder or liquid
detergents.
If the wash is not heavily stained, select
a lower temperature than indicated on
the wash care label.
For instance, since a main wash generally gives good results for a normal
load, the pre-wash cycle has been
made a user selectable option, saving
time,water and energy over older full
cycle machines.
7
Preparing the Laundry
Preparing the Laundry
The headings numbered (
show the operating sequence and can
be used as a brief guide.
1,2,3,...)
Before washing
1Prepare the wash load
Empty all pockets.
Most garments have a textile care label
in the collar or side seam. Sort the
laundry by care label and color.
Only wash items that are labeled machine washable by the manufacturer.
Dark fabrics often contain “excess dye”
and should be washed separately several times before being included in a
mixed load.
Delicate fabrics should be washed separately using a delicates programme.
Only wash wool or wool mixtures if they
are labeled machine washable on the
textile care label.
Pre-treat the laundry
Badly soiled areas (e.g. collars and
cuffs) and water soluble stains can be
pre-treated with bar soap, stain
remover, or detergent mixed into a solution or paste.
Do not use detergents containing solvents in the machine.
Foreign objects inadvertently left in
pockets (e.g. nails, coins, paper
clips, etc.) can cause damage to
clothes and the machine. Damage
to the machine can occur if wires
from underwire bras come loose.
Do not wash underwire bras in the
machine without ensuring that wires
are secure.
Sort the laundry
8
Preparing the Laundry
2Press the “Door” button to open
the door
3Load the machine
Unfold the laundry and place it in the
drum. For best results we recommend
washing mixed loads consisting of both
large and small items. This improves
the washing effectiveness and helps
distribute the load evenly to keep the
machine stable and reduce noise during spinning.
Recommended load sizes are noted
below:
COTTONS..................5.0kg
PERMANENT PRESS . . . . . . . . . 2.5 kg
DELICATES.................1.0kg
HANDWASH/WOOLLENS . . . . . . 1.5 kg
Rinse......................5.0kg
With curtains: Remove lead weights
and strips and place in a laundry bag.
Woollens and knitted garments should
be turned inside out if recommended
by the manufacturer.
To start a programme
1Turn the programme selector
to Start / Finish
2Press the “ON/OFF” button
3Press any additional option
buttons desired
(See the “Delay start” section if this feature is desired.)
4Select spin cycle speed
5Turn the programme selector to the
desired programme
The programme selector can be turned
to the left or the right.
4Close the machine door
Make sure there are no clothes caught
between the drum door and seal.
5Add detergent
See section “Adding detergent” for details.
9
End of programme
End of programme
After washing
1 Turn the programme selector
switch to “Start/Finish”
2 Press the “ON/OFF” button.
3 Press the “Door” button.
Do not attempt to remove laundry
from the machine if the drum is
turning. You may seriously injure
yourself. If the drum turns with
the door open, contact the Miele
Service Department.
4 Remove the wash.
5 Check the folds in the door seal
for any small articles such as
buttons or nails which may be
lodged there.
Make sure the drum is empty by
manually turning it completely
around or, during the next use,
items may be damaged (e.g. shrink)
or cause other laundry to discolor.
10
6 Close the drum door.
Changing the programme sequence
Changing the programme sequence
To cancel a programme:
Turn the programme selector to
“Start/Finish”.
To omit a programme stage:
A programme stage must first be
reached to be omitted:
To interrupt a programme:
Press the “ON/OFF” buttton.
To continue the programme, turn the
machine back on.
To change an incorrectly selected
programme:
Turn the programme selector switch
to “Start/Finish”.
When only the “On” lamp is lit, a new
programme can be selected.
To change a programme which has
been “locked” using the Child Safety
feature, see the “programmable functions” section.
Turn the programme selector to
“Start/Finish”
As soon as the PROGRAMME SEQUENCE indicator lamp for the stage
you wish starts flashing:
Turn the programme selector switch
to the desired programme.
11
Adding detergent
Adding detergent
Detergent should be added to compartment j at the beginning of each wash
cycle.
Miele recommends the use of low-sudsing detergents, as their characteristics
allow them to perform better in frontloading machines than regular powder
or liquid detergents.
Due to the Miele “Eco-System”, approximately 2/3 of the manufacturer’s recommended amount of detergent is generally sufficient for excellent wash results.
If you have difficulty finding a low-sudsing detergent, contact Miele Limited.
It is important to add the correct amount of detergent, because...
...too little detergent can result in:
– grey laundry
– grease/stains not being removed
– lime deposits on the heater elements
and drum.
...too much detergent can result in:
– excessive foam
– low level of agitation
Do not use chlorine bleach! Chlorine
bleach will damage the machine.
For extremely hard water:
Water is taken in through compartment
j in the main wash. If your water is extremely hard (above 400 ppm CaCO
and the capacity of compartment j is
insufficient for the amount of detergent
needed, a Service Technician can reprogramme the machine so that water
and detergent can also be taken in
through compartment i.
For small loads:
– Gradually reduce the amount of
detergent used with each small load.
– Check the wash results and the con-
dition of the laundry.
– If the laundry is not clean or if it is
grey or hard to the touch, add
slightly more detergent the next time
you use the machine.
)
3
– poor cleaning and rinsing results.
Water Softeners
If you wish to use a water softener to
cut down on detergent usage in hard
water areas:
– add the amount of detergent necess-
ary for a soft water area.
– Following the manufacturer’s recom-
mendations,add the specified
amount of water softener.
Always add the detergent first, in compartments i and j followed by the
softener, to ensure that both are
properly dispensed.
12
Adding fabric softener or starch
Adding fabric softener or starch
If fabric softener is desired, it will work
more effectively and be gentler on the
clothes if it is dispensed in the final
rinse cycle of the wash, rather than in
the tumble dryer through the use of softener sheets. To automatically dispense
fabric softener:
Open the lid of compartment p.
At the end of the programme a small
amount of water will normally remain in
compartment p. A high water level in
this compartment, however, may indicate that the siphon is clogged or the
dispenser drawer was opened during
the last rinse cycle, thereby interrupting
the distribution of fabric softener. In this
case, the siphon tube should be
cleaned as described on Page 21.
Starch
If starch is used for shirts, blouses,
table cloths, napkins, etc., pour the liquid starch into compartment p (use
the some procedure as for fabric softener).
Never mix fabric softener and starch
together in compartment p. This can
lead to a blockage in the washer’s overflow system.
Following the manufacturer’s recommendations, pour the specified
amount of liquid fabric softener into
compartment p. However, do not exceed the maximum fill level marked
inside the compartment, as any excess will prematurely activate the siphon and be wasted.
Close the compartment lid and push
in the dispenser drawer.
The conditioner will automatically be
dispensed during the last rinse cycle.
Using the “Starch” programme for
dispensing liquid starch
– Prepare the starch solution in accor-
dance with the manufacturer’s instructions and pour it into compartment i.
– Use the normal water level (Water
Plus button “out”) when starching so
that the solution will have the maximum effect.
“Without final spin” can be selected to
reduce fabric creasing.
13
Programmes
Programmes
The run time of front-loading machines is longer than that for most top-loading, vertical tub machines. This is because front-loading machines balance the 5 basic
washing factors (mechanical action, water, detergent, temperature and time) diffently than do vertical tub machines. Miele’s front-loading machines use an advanced hydromatic washing action, precise and steady temperatures, less water
and detergent than vertical tub machines but more time. The longer run time is
part of the equation that produces Miele’s excellent wash results.
COTTONS
For cotton fabrics without special finishes. For most everyday loads, e.g.
sheet, towels, jeans, sweatshirts, tshirts underwear.
1) Water levels used:
wash - low
rinse - low
2) Rinse cycles used:
Normal programme - four
Rapid wash- two
X = additional options
Temperature guidelines:
30 – 40°C – dark coloured items.
40 – 50°C – light coloured items.
60 – 95°C – exclusively white items.
80°C – e.g. whites. such as socks,
which would commonly be bleached in
a top-loading, vertical tub machine.
95°C – e.g. diapers.
max/load:5.0 kg (11 lbs.)
max/spin:1600 rpm
Normal run time:1 h 48 min
Rapid wash time: 1 h 06 min
14
Programmes
PERMANENT PRESS
For cotton blend fabrics, polyester
blends and other synthetics such as acrylic, nylon and ramie.
1) Water levels used:
wash - low
rinse - high (to reduce wrinkling)
2) Rinse cycles used:
Normal programme - three
Rapid wash- two
X = additional options
Temperature guidelines:
30°C –dark fabrics which are a blend
or 100% synthetic fabrics.
40°C – 50°C – light coloured cotton or
synthetic items.
60°C –white polyester/cottons items.
max/load:2.0 kg (4.5 lbs.)
max/spin:900 rpm
Normal run time:1 h 07 min
Rapid wash time: 34 min
15
Loading...
+ 33 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.