PS 1201B V2.0
Installation plan
Small steam steriliser
PS 1201B V2.0
en-GB
M.-Nr. 10 181 110 - 00 /
2015-02-02
Installation plan
2
Electrical connection (EL)
Voltage (permitted fluctuations +/- 10%) V / Hz AC 230 / 50
Connected load W 2600
Fusing (surge-proof) A 16
Length of supply lead with plug m 2.0
Variations in the following countries:
GB
Voltage (permitted fluctuations +/- 10%) V / Hz AC 230 / 50
Connected load W 2600
Fusing (surge-proof) A 13
Length of supply lead with plug m 2.0
AUS
Voltage (permitted fluctuations +/- 10%) V / Hz AC 230 / 50
Connected load W 2000
Fusing (surge-proof) A 10
Length of supply lead with plug m 2.0
Cold water (KW)
Temperature °C max. 25
Mains water hardness °dH max. 25
Mains water conductivity level μS/cm max. 375
Flow pressure kPa min. 150
max. 600
Flow rate l/min min. 3.0
Connection hose length (supplied) m 1.5
On-site threaded union in accordance with DIN 44991 (flat sealing) Inch 3/4" male thread
USA: 11.5 NH
Integrated safety device to prevent contamination of potable water supply in accordance with DIN 1988 or DIN
EN 1717.
Waste water (AW)
Drain hose (internal dia. x wall thickness x length) mm 22 x 6 x 1500
Flow rate l/mm max. 10 (brief flow rate)
On-site hose sleeve for drain hose (outer dia. x length) mm 22 x 30
The on-site drain connection must be at least 200 mm below the machine. The drain hose must be laid such
that it slopes constantly down towards the on-site drain connection without any loops where water could col‐
lect.
Machine feet (F)
Height-adjustable mm 0 / +10
Diameter of machine feet mm 25
Heat dissipation rate to installation site
Steriliser kWh/h 0.4
Sterile load after removal kWh/h 0.3
Loading...