Mercedes-Benz Bluetooth Cradle Installation Manual
Accessories
Installation and Operation
Instructions
Mercedes-Benz Bluetooth® Cradle for
Motorola K1 KRZR phone
© 2008, Daimler AG
02/08
03F065-07
1
M+P-03F-7082
1
খ
Application
These installation instructions are valid for
vehicles with an MHI hands-free communication system and a Mercedes-Benz-approved Motorola K1 KRZR phone with approved
software level. Approved mobile telephones
are listed and can be purchased on the Internet at www.wireless4mb.com or call
1-800-910-1021 to speak to a wireless telephone specialist.
Parts included
• (1) Mercedes-Benz Bluetooth
®
Cradle
for Motorola K1 KRZR phones
Note
Please contact your local Mercedes-Benz
Center if you encounter difficulties when
operating the Mercedes-Benz Hands-Free
Communication System.
GWarning
Always use approved phones with
the Mercedes-Benz K1 Cradle.
Operating a non-approved phone or
radio transmitter with its own
attached or built-in antenna while
the engine is running can interfere
with the vehicle’s electronic system.
For safety reasons, the driver should
not use the mobile phone while the
vehicle is in motion. We encourage
the driver to stop the vehicle in a
safe location before answering or
placing a call.
2
Contents
Notes
More information can be found on the
Internet at www.wireless4mb.com or call
1-800-910-1021 to speak to a wireless
activation specialist.
We reserve the right to change technical
details from those shown in the illustrations
contained in these installation instructions.
These installation instructions also refer to
the Vehicle Operator
’s Manual, COMAND
Operator
’s Manual, and mobile telephone
manual. Please keep them available for
reference.
Installing the Mercedes-Benz K1
Cradle
컄 3
Inserting mobile telephone
컄
4
Pairing the Motorola K1 KRZR
phone with the Mercedes-Benz
K1 Cradle
컄 6
Establishing a Bluetooth
®
con-
nection
컄 7
Connecting the Motorola K1
KRZR phone and Mercedes-Benz
K1 Cradle manually
컄 8
Disconnecting the Bluetooth
®
connection
컄 9
Removing Motorola K1 KRZR
phone
컄 10
Detaching the Mercedes-Benz
K1 Cradle
컄 11
3
Installing the Mercedes-Benz K1 Cradle
1. Insert the Mercedes-Benz K1 Cradle (1)
into the latches on the pre-installed MHI
contact plate (2), located in the center
console.
To insert the Mercedes-Benz K1 Cradle (1),
slide it upwards until it clicks into place.
2
1
M+P-03F-5601
4
Inserting mobile telephone
The Motorola K1 KRZR phone can only be
used inside of the Mercedes-Benz K1 Cradle
for use in hands-free mode. The MercedesBenz K1 Cradle uses Bluetooth
®
technology
to connect with your Motorola K1 KRZR
phone. Make sure you have established a
Bluetooth
®
connection before using the
Mercedes-Benz K1 Cradle, see pairing
procedure on 컄 6.
When using the Motorola K1 KRZR phone in
the cradle, the Motorola K1 KRZR phone will
also be charged and connected to the vehicle
’s external mobile antenna for improved
reception.
Close the flip screen of the Motorola K1
KRZR phone before inserting it into the
Mercedes-Benz K1 Cradle.
Note
Closing the mobile phone flip screen ends
the call.
1. Insert the Motorola K1 KRZR phone (3)
into the cradle (1) as illustrated.
1
3
M+P-03F-7084
5
2. Insert the Motorola K1 KRZR phone (3)
into the cradle (1) and close the
connector (4). Make sure that connector (4)
connects to Motorola K1 KRZR phone (3).
1
3
4
M+P-03F-7086
6
Pairing the Motorola K1 KRZR phone with
the Mercedes-Benz K1 Cradle
Make sure that the starter switch is in
position 1, 2 o r 3 (see the Vehicle Operator
’s
Manual).
1. With Mercedes-Benz K1 Cradle connected to the vehicle press button (5) for
approx. 2–3 seconds.
The LED (6) will begin to flash rapidly. The
Mercedes-Benz K1 Cradle is in Discovery
Mode and can be detected by the Motorola
K1 KRZR phone. The Mercedes-Benz K1
Cradle will appear as “MB KRZR Cradle” on
the Motorola K1 KRZR phone.
2. For instructions on how to get the
mobile telephone ready for pairing, see the
mobile telephone manual or visit
www.wireless4mb.com. Once the Motorola
K1 KRZR phone and Mercedes-Benz K1
Cradle find each other the Motorola K1 KRZR
phone will prompt the user to enter a PassKey.
3. When prompted, enter the Pass-Key
62872 into the Motorola K1 KRZR phone.
5
6
M+P-03F-7087
7
Note
As soon as the Pass-Key has been entered
and accepted, you will see a display message on your mobile phone indicating that
the connection has been established. The
connection between the mobile phone and
the cradle is cut off automatically.
4. The Motorola K1 KRZR phone is now
ready for use with the Mercedes-Benz
Hands-Free Communication System.
Note
A maximum of 4 Motorola K1 KRZR phones
can be paired with the Mercedes-Benz K1
Cradle. If a fifth Motorola K1 KRZR phone is
paired with the Mercedes-Benz K1 Cradle,
then the information stored from the first
Motorola K1 KRZR phone which was paired
with the Mercedes-Benz K1 Cradle will be
replaced.
Establishing a Bluetooth
®
connection
1. Insert the mobile phone into the cradle
and turn the key to position 1, 2 or 3 in the
ignition lock (see the vehicle Owner’s
Manual).
Notes
A Bluetooth connection will not be established if the Motorola K1 KRZR is not inserted
in the cradle.
The Mercedes-Benz K1 Cradle will search for
a paired Motorola K1 KRZR phone and
reconnect.
If the connection between the Mercedes-Benz K1 Cradle and Motorola K1 KRZR
phone is not established automatically, it is
possible to establish a connection manually
(see 컄 8).
SMS messages can not be accessed via the
COMAND or radio while the Bluetooth
®
connection is established.
8
The Motorola K1 KRZR phone allows viewing
of incoming SMS.
Not every ring-tone of the Motorola K1 KRZR
phone is supported by the COMAND or
radio.
3-way-calling and call waiting are not
supported in the Mercedes-Benz K1 Cradle.
An audible beep will notify a waiting call.
The roaming indication is not supported by
the COMAND or radio.
The Tele Aid System (emergency call system) will continue to function independently
of the hands-free phone system as designed
as long as there is a valid service contract, a
telephone service and a GPS coverage.
Connecting the Motorola K1 KRZR phone
and Mercedes-Benz K1 Cradle manually
Press the Bluetooth
®
button on the
Mercedes-Benz K1 Cradle.
or:
For all Mercedes-Benz vehicles up to model
year 2008 (with the exception of the model
year 2007 S-Class/CL-Class):
• Press button on the COMAND or
radio.
For model year 2007 S-Class/CL-Class vehicles:
• Using the COMAND Controller, select
“Telephone” 씮 “Telephone” 씮 “Tele-
phone on”.
Note
Before manual connection, the Motorola K1
KRZR phone must previously be paired with
the Mercedes-Benz K1 Cradle, see pairing
procedure on 컄 6.
9
Disconnecting the Bluetooth® connection
The connection between the Motorola K1
KRZR phone and the Mercedes-Benz K1
Cradle is automatically disconnected when
the Motorola K1 KRZR phone is removed
from the Mercedes-Benz K1 Cradle.
10
Removing Motorola K1 KRZR phone
1. Open the connector (4) as illustrated
and lift up the Motorola K1 KRZR phone (3).
2. Remove the Motorola K1 KRZR
phone (3) from the cradle (1) as illustrated.
3
4
M+P-03F-7089
1
3
M+P-03F-7091
Loading...