
GB Operator!s manual 2-13
E Bruksanvisning 14-25
S
K Brugsanvisning 26-38
D
F
I Käyttöohje 39-51
O Bruksanvisningen 52-63
N
R Manuel d!utilisation 64-77
F
L Gebruiksaanwijzing 78-91
N
I
T Istruzioni per l!uso 92-105
E
S Manual de instrucciones 106-119
E Bedienungsanweisung 120-133
D
T Instruções para o uso 134-147
P
H
U Használati utasítás 148-160
L Instrukcja obsĝugi 161-174
P
EE Käsitsemisõpetus 175-187
L
V Lieto"anas pamÛcďba 188-200
T Naudojimosi instrukcijos 201-213
L
K Návod na obsluhu 214-226
S
H
R Priruìnik 227-238
I Navodila za uporabo 239-251
S
Z Návod k pou#ití 252-264
C
O InstrucŇiuni de utilizare 265-277
R
B
G əɣɓɗɋɗɍɚɛɋɗ ɐɉ
Ɏɓɚɘɔɗɉɛɉɟɑɨ 278-295
U əɜɓɗɋɗɍɚɛɋɗ ɘɗ
R
ɦɓɚɘɔɜɉɛɉɟɑɑ 296-307
R OǰdzǯȌDZǿ ȅǾȋȀDZȇǿ 308-319
G
R Kullanõm kõlavuzu 320-332
T
TRIMMAC
LT25NCOP

IDENTIFICATION (WHAT IS WHAT?)
Assist Handle
Shield
Trimmer
Head
Shaft
Muffler
Fuel Mix Fill Cap
Starter Handle
ON/OFF Switch
Throttle Trigger
Choke Lever
Spark Plug
Locking Sleeve
Assembly
Primer Bulb
Manual
Wrench
IDENTIFICATION OF SYMBOLS
A. WARNING! Thistrimmer canbe dangerous! Careless or improper use can cause
serious or even fatal injury.
B. Read and understand the instruction manual before using the trimmer.
C. With this handle, only use trimmer head. Never use bladesor flailing devices with this
tool.
D.
WARNING! The trimmer line can throw objects violently. You can be blinded or
injured. Always wear eye protection.
E. Always use:
Ear protection
Protective glasses or visor
F. Assist handle to be positioned only below the arrow.
G. The operator of the machine must insure that no one comes within a 15 meter radius
while working. Whenseveral operatorsare working within the same areaa safety dis-
tance of at least 15 meters must be observed.
H. Use unleaded or quality leaded petrol and two--stroke oil mixed at a ratio of 2.5%.
I. Engine ON/OFF Switch.
J. Guaranteed sound power level according to Directive 2000/14/EC
K.
Sound pressure level at 7,5 meters

SAFETY RULES
WARNING: When using gardening
appliances, basic safety precautions should always be followed to reduce the risk of fire and
serious injury. Read and follow all instructions.
This power unit can be dangerous! Operator is
responsible for following instructions and warnings on unit and in manual. Read entire instruction manual before using unit! Be thoroughly familiar with the controls and the proper use of the
unit. Restrict the use of this unit to persons who
read, understand, and follow instructions and
warnings on unit and in manual. Never allow
children to operate this unit.
INSTRUCTION
MANUAL
DANGER: Never use blades, wire, or
flailing devices. This unit is designed for line
trimmer use only. Use of any other acc essories
or attachments will increase the risk of injury.
WARNING: Trimmer line throws ob-
jects violently. You and others can be blinded/
injured. Wear safety glasses and leg protection. Keep body parts clear of rotating line.
Keep children, bystanders, and animals 15 meters away. If approached stop unit immediately.
If situations occur which are not covered in
this manual, use care and good judgement. If
you needassistance, contact your authorized
service dealer.
OPERATOR SAFETY
WARNING: This machine produces
an electromagnetic field during operation. Under
some circumstances, this field may interfere
with active or passive medical implants. To reduce the risk of serious or fatal injury, we recommend persons with medical implants to consult
their physician and the medical implant
manufacturer before operating this machine.
SAFETY INFORMATION
ON THE UNIT
S Dress properly. Always wear safety
glasses or similar eye protection when operating, or performing maintenance, on
your unit (safety glasses are available).
Eye protection should be marked Z87.
S Always wear face or dust mask if operation
is dusty.
S Always wear heavy, long pants, long
sleeves, boots, and gloves. Wearingsafety
leg guards is recommended.
S Always wear foot protection. Do not go
barefoot or wear sandals. Stay clear of
spinning line.
S Secure hair above shoulder length. Secure
or remove loose clothing or clothing with
loosely hanging ties, straps, tassels, etc.
They can be caught in moving parts.
S Being fully covered also helps protect you
from debris and pieces of toxic plants
thrown by spinning line.
S Stay alert. Do not operate this unit when you
are tired, ill, upset or under the influence of alcohol, drugs, or medication. Watch what you
are doing; use common sense.
S Wear hearing protection.
S Mufflers fitted with catalytic converters get
very hot during use and remain so for some
time after stopping. This also applies at idle
speed. Contact can result in burns to the skin.
Remember the risk of fire!
S Never start or run inside a closed room or
building. Breathing exhaust fumes can kill.
S Keep handles free of oil and fuel.
UNIT / MAINTENANCE SAFETY
S Disconnect the spark plug before performing
maintenance except carburetor adjustments.
S Look for and replace damaged or loose
parts before each use. Look for and repair
fuel leaks before use. Keepin good working
condition.
S Replace trimmer head parts that are
chipped, cracked, broken, or damaged in
any other way before using the unit.
S Maintain unit according to recommended pro-
cedures. Keep cutting line at proper length.
S Use only 2 mm diameter line. Never use wire,
rope, string, etc.
S Install required shield properly before using
the unit. Use only specified trimmer head;
make sure it is properly installed and securely fastened.
S Make sure unit is assembled correctly as
shown in this manual.
S Make carburetor adjustments with lower
end supported to prevent line from contacting any object.
S Keep others away when making carburetor
adjustments.
S Use only recommended accessories and
replacement parts.
S Have all maintenance and service not ex-
plained in this manual performed by an authorized service dealer.
3

FUEL SAFETY
S Mix and pour fuel outdoors.
S Keep away from sparks or flames.
S Use a container approved for fuel.
S Do not smoke orallow smoking near fuel or
the unit.
S Avoid spilling fuelor oil. Wipeup all fuelspills.
S Move at least 3 meters away from fueling
site before starting engine.
S Stop engine and allow to cool before re-
moving fuel cap.
S Always store gasoline in a container ap-
proved for flammable liquids.
CUTTING SAFETY
WARNING: Inspect the area before
each use. Remove objects (rocks, broken
glass, nails, wire, etc.) which can be thrown
by or become entangled in line. Hard objects
can damage the trimmer head and bethrown
causing serious injury.
S Use only for trimming, scalping, mowing
and sweeping. Do not use for edging,pruning or hedge trimming.
S Keep firmfooting and balance. Do notover-
reach.
S Keep all parts of your body away from muf-
fler and spinning line. Keep engine below
waist level. A hot muffler can causeserious
burns.
S Cut from your right to your left. Cutting on
left side ofthe shield will throw debris away
from the operator.
S Use only in daylight or good artificial light.
S Use only for jobs explained in this manual.
TRANSPORTING AND STORAGE
S Allow the engine to cool; secure unit before
storing or transporting in vehicle.
S Empty fuel tank before storing or transport-
ing theunit. Use upfuel leftin thecarburetor
by starting engine and letting it run until it
stops.
S Store unit andfuel in an areawhere fuelva-
pors cannot reach sparks or open flames
from water heaters, electric motors or
switches, furnaces, etc.
S Store unitso line limiter cannotaccidentally
cause injury. Unit can be hung by the shaft.
S Store the unit out of the reach of children.
S Secure the machine during transport.
SPECIAL NOTICE: Exposure to vibra-
tions thr
ough prolonged use of gasoline powered hand tools could cause blood vessel or
nerve damage in the fingers, hands, and
joints of people proneto circulation disorders
or abnormal swellings. Prolonged use in cold
weatherhas beenlinked to blood vesseldamage in otherwise healthypeople. If symptoms
occur such as numbness, pain, loss of
strength, change in skin color or texture, or
loss of feeling in the fingers, hands, or joints,
discontinue the use of this tool andseek medical attention. An anti-vibration system does
not guarantee the avoidance of these problems. Users who operate power tools on a
continual and regular basis must monitor
closely theirphysical conditionand the condition of this tool.
WARNING: Make sure unit is proper-
ly assembled and all fasteners are secure.
Examine parts for damage. Do not use damaged parts.
It is normal for the fuel filter to rattle in the
empty fuel tank.
Finding fuel or oil residue on muffler is normal
due to carburetor adjustments and testing
done by the manufacturer.
SHAFT ASSEMBLY
CAUTION:
When assembling shaft, place
the unit on a flat surface for stability.
1. Align grooves on upper and lower shafts.
Upper Shaft
Lower Shaft
Grooves
2. Push the two shafts together until the lower
shaft is fully seated in the upper shaft (the
shafts lock into place).
3. Slide lower locking sleeve assembly over
upper locking sleeve assembly and tighten by turning clockwise.