Makita DUB361 Instruction Manual
1
ENGLISH (Original instructions)
INSTRUCTION MANUAL
IMPORTANT: Read Before Using.
Cordless Blower
DUB361
014602
2
ENGLISH (Original instructions)
SPECIFICATIONS
Model DUB361
Air volume (HIGH) 4.4 m3/min
Capacities
Air volume (LOW) 2.6 m3/min
HIGH 17,000
No load speed (min-1)
LOW 10,000
(without long nozzle) 420 mm
Overall length
(with long nozzle) 905 mm
Net weight 3.1 kg
Rated voltage D.C. 36 V
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
END012-4
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Take particular care and attention.
･ Read instruction manual.
･ Keep a hand away from rotating parts.
･ Danger; be aware of thrown objects.
･ Keep bystanders away.
･ Wear eye and ear protection.
･ Do not expose to moisture.
･ Only for EU countries
Do not dispose of electric equipment or
battery pack together with household
waste material!
In observance of the European
Directives, on Waste Electric and
Electronic Equipment and Batteries and
Accumulators and Waste Batteries and
Accumulators and their implementation
in accordance with national laws,
electric equipment and batteries and
battery pack(s) that have reached the
end of their life must be collected
separately and returned to an
environmentally compatible recycling
facility.
ENE018-1
Intended use
The tool is intended for blowing dust.
ENG102-3
Noise
The typical A-weighted noise level determined
according to EN15503:
Sound pressure level (L
pA
) : 82.3 dB (A)
Sound power level (L
WA
) : 94.7 dB (A)
Uncertainty (K) : 1.6 dB (A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN15503:
Work mode : operation without load
Vibration emission (a
h
) : 2.5 m/s2 or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
Cd
Ni-MH
Li-ion
3
ENH021-7
For European countries only
EC Declaration of Conformity
We Makita Corporation as the responsible
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Cordless Blower
Model No./ Type: DUB361
Specifications: see "SPECIFICATIONS" table.
are of series production and
Conforms to the following European Directives:
2000/14/EC, 2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN15503
The technical documentation is kept by:
Makita International Europe Ltd.
Technical Department,
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
The conformity assessment procedure required by
Directive 2000/14/EC was in Accordance with annex V.
Measured Sound Power Level: 94.7 dB (A)
Guaranteed Sound Power Level: 96 dB (A)
22.7.2013
000230
Tomoyasu Kato
Director
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, 446-8502, JAPAN
ENB116-5
BLOWER SAFETY WARNINGS
1. Always use protective goggles, a cap and
mask when using the blower.
2. Never point the nozzle at anyone in the
vicinity when using the blower.
3. Warning - Electric shock could occur if used
on wet surfaces. Do not expose to rain. Store
indoors.
4. Never block suction inlet and/or blower outlet.
• Do not block suction inlet or blower outlet
to clean up in dusty areas.
• Do not use the blower with a tapered
nozzle smaller than the original one, such
as a new nozzle obtained by attaching an
extra diameter-reduced hose or smaller
hose to the nozzle top end.
• Do not Use the blower to inflate balls,
rubber boat or the similar.
Increased motor revolution may cause dangerous
fan breakage and result in serious personal injury.
Heated motor and control circuit may cause a fire.
5. Keep children, other bystanders and pets
away from the blower while operating.
6. Do not operate the blower near open window,
etc.
7. Operating the blower only at reasonable
hours is recommended - not early in the
morning or late at night when people might be
disturbed.
8. Using rakes and brooms to loosen debris
before blowing is recommended.
9. It is recommended to slightly dampen
surfaces in dusty conditions or use mister
attachment available on the market.
10. It is recommended to use the long nozzle so
the air stream can work close to the ground.
11. The blower is not intended for use by persons
with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge.
12. Young children should be supervised to
ensure that they do not play with the blower.
13. Do not insert fingers or other objects into
suction inlet or blower outlet.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
ENC007-8
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
1. Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product
using battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
Loading...