COPPER-FIN II®
WATER HEATER
Submittal Sheet
CFE-Sub-06
COPPER-FIN II® GAS WATER HEATER (MODELS CF 401-2071)
JOB NAME ______________________________________________________________________
LOCATION ______________________________________________________________________
ARCH./ENGR.____________________________________________________________________
WHOLESALER __________________________________________________________________
MECH. CONTRACTOR ___________________________________________________________
MODEL NO. _____________________________________________________________________
TYPE GAS ______________________________________________________________________
Btu/hr INPUT_____________________________________________________________________
RECOVERY RATE IN GPH_______________________________________@________°F RISE NOTES
Standard Features
•85% Thermal Efficiency
•ASME Copper Finned Tube Heat Exchanger
•Gasketless Heat Exchanger Design
•Proportional Firing
•Built-In Sequencer with up to 4 Stages of Operation
•Digital Operator Interface Panel
•Sealed Combustion Chamber
•Stainless Steel Burners
•Low NOx Operation Exceeds the
most Stringent Air Quality Requirements
•160 PSI Working Pressure
•All Bronze Circulating Pump
•Pump Delay
•Glass-Lined Water Surfaces
•Loch-Heat Ceramic Tile Combustion Chamber
•Hot Surface Ignition
•ASME Temperature & Pressure Relief Valve
•Inlet & Outlet Temperature Gauges
•Referenced Gas Valves
•Field Convertible Air Inlet Connection
•Adjustable High Limit w/ Manual Reset
•Combustion Air Filter
•Freeze Protection
•Flow Switch
•24 Volt Control System
•BMS Terminal Strip
•5 Year Limited Warranty on Heat Exchanger (See warranty for details)
Optional Equipment
Place an X in the box by all options that apply
Alarm Bell
Contacts for Air Louvers Contacts on any Failure Cupro-Nickel Heat Exchanger Down Stream Test Valves
High Gas Pressure Switch w/ Manual Reset Low Gas Pressure Switch w/ Manual Reset Low Water Cut-Off w/ Manual Reset & Test Run Time Contacts
Multi-Stack Frame
Combustible Floor Shield (CF 401-751) MP2 Sequencer
Firing Controls
M9 Hot Surface Ignition with Electronic
Supervision (Standard)
M13 GE GAP/FM/IRI
M7 California Code
Loading...