Linksys SM01 User Manual

A Division of Cisco Systems, Inc.

Stacking/Wall Mount Bracket Instructions

®

Wall Mounting

Mount your wireless devices up high for optimum signal cov­erage or use it to get your wired networking devices off your
desk and out of the way.

1 Locate two flat-head screws (not included) designed for

your wall’s composition. Mark two spots on the wall
3-5/16 inches (8.4 cm) apart, then install the screws into
the wall.

2 Remove the four rubber feet from the device, line up and

snap the mounting plate onto the device as shown.

3 Line up the Bracket’s mounting holes with the screws on

the wall, place the device over the screws, and slide it
down into place.

Mounting

Holes

5

3

"

16

(8.4 cm)

Figure 1: Wall Mounting

Stacking

The Stacking/Wall Mount Bracket can also be used to
securely stack Linksys compact components on top
of standard-sized ones. Its feet mate to the top of a
standard-sized device, while depressions on the
bracket accept the foot-spacing of the smaller
devices.

Remove the four rubber feet from your device, line up
and snap the Stacking/Wall Mount Bracket onto the
device, as shown.

Stacking/Wall Mount Bracket

SM01-AD-50929NC BW

Figure 2: Stacking