LINKSYS EA6900 User Manual

Regulatory Information EA6900
Table of Contents
Table of Contents
Wireless Regulatory Information 1
FCC Statement. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Mexico Regulatory Statement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
FCC Radiation Exposure Statement . . . . . . . . . . . . . . . . . . . . . . . . . 1
Safety Notices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Industry Canada Statement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Restrictions in the 5 GHz Band . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Avis d’Industrie Canada . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Restrictions dans la bande 5 GHz . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Wireless Disclaimer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Avis de non-responsabilité concernant les appareils sans fil . . . . . . . . . . . 3
1999/5/EC (R&TTE Directive) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Wireless Equipment
(Wireless-AC/N/G/A/B Products). . . . . . . . . . . . . . . . . . . . . . . . . . . .4
National Restrictions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Product Usage Restrictions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Technical Documents on
www.linksys.com . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
WEEE Information 6
User Information for Consumer Products Covered by EU Directive
2002/96/EC on Waste Electric and Electronic Equipment (WEEE) . . . . . . . 6
i

Wireless Regulatory Information

Wireless Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment or devices
Connect the equipment to an outlet other than the receiver’s
Consult a dealer or an experienced radio/TV technician for assistance
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
IEEE 802.11b or 802.11g operation of this product in the USA is firmware-limited to channels 1 through 11.
The device for the band 5150-5250 MHz is only for indoor usage to reduce the potential for harmful interference to co-channel mobile satellite systems.

Mexico Regulatory Statement

This device and it’s antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi­transmitter product procedures.

Safety Notices

WARNING: Do not use this product near
water, for example, in a wet basement or near a swimming pool.
WARNING: Avoid using this product during an
electrical storm. There may be a remote risk of electric shock from lightning.
WARNING: This product may contain
chemicals, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.

Industry Canada Statement

CAN ICES-3 (B)/NMB-3 (B) Operation is subject to the following two conditions:
1. This device may not cause interference and
2. This device must accept any interference, including interference that may cause undesired operation of the device.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.
The device could automatically discontinue transmission in case of absence of information to transmit, or operational failure. Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive codes where required by the technology.
Industry Canada Radiation Exposure Statement
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 25 cm between the radiator and your body.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 25 cm between the radiator & your body.
Cet appareil et son (ses) antenne (s) ne doivent pas être situés à proximité ou fonctionner en association avec une autre antenne ou un autre émetteur autre qu’en respectant les procédures d’ Industrie Canada relatives au fonctionnement des dispositifs multi-émetteurs.
1
Wireless Regulatory Information

Restrictions in the 5 GHz Band

The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile satellite systems.
This device has been designed to operate with an antenna having a maximum gain of 2.44 dBi and 3.89 dBi at 2.4 GHz and 5 GHz respectively. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.
The maximum antenna gain (Please see the table below) permitted (for devices in the bands 5250-5350 MHz and 5470-5725 MHz) to comply with the E.I.R.P. limit and because high power radars are allocated as primary users (meaning they have priority) in 5250-5350 MHz and 5650-5850 MHz, these radars could cause interference and/or damage to license exempt LAN devices.
No.
Antenna
Type
For 2.4
GHz Gain
(dBi)
For 5 GHz
Gain (dBi)
Antenna
Connector
1 Dipole 2.6 3.7 R-SMA 2 Dipole 4.18 3.35 R-SMA 3 Dipole 2.99 4.43 R-SMA
Additional requirements for the band 5600-5650 MHz: Until further notice, devices subject to this Section shall not be capable of transmitting in the band 5600­5650 MHz, so that Environment Canada weather radars operating in this band are protected.

Avis d’Industrie Canada

CAN ICES-3 (B)/NMB-3 (B). L’utilisation de ce dispositif est autorisée seulement aux
conditions suivantes :
1. il ne doit pas produire de brouillage et
2. il doit accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.
Pour les produits disponibles sur le marché aux États­Unis et au Canada, seuls les canaux de 1 à 11 peuvent être utilisés. La sélection d’autres canaux n’est pas possible.
Le dispositif peut automatiquement cesser d’émettre en cas d’absence d’informations à transmettre, ou à cause d’une défaillance technique. Notez que l’objet n’est pas d’interdire la transmission des informations de contrôle ou de signalisation ou l’utilisation de codes répétitifs lorsque requis par la technologie.
Avis d’Industrie Canada concernant l’exposition aux radiofréquences
Ce matériel est conforme aux limites établies par IC en matière d’exposition aux radiofréquences dans un environnement non contrôlé. Ce matériel doit être installé et utilisé à une distance d’au moins 25 cm entre l’antenne et le corps de l’utilisateur.

Restrictions dans la bande 5 GHz

L’appareil pour la bande de 5150 à 5250 MHz est conçu pour usage à l’intérieur seulement afin de réduire le potentiel d’interférences pour les systèmes mobiles par satellite qui utilisent le même canal.
Cet appareil a été concu pour fonctionner avec une antenne ayant un gain maximum de 2.44 dBi et 3.89 dBi sur les bandes 2.4Ghz et 5 Ghz respectivement. L’utilisation d’antenne ayant un gain supérieur est strictement interdit par le règlement d’Industrie Canada. L’impédance d’antenne requise est 50 ohms.
Le gain maximum autorisé (voir le tableau ci-dessous pour les appareils dans les bandes 5250-5350 Mhz et 5470­5725 Mhz) pour être conforme avec la limite de P.I.R.E. et parce que les radars de haute puissance sont les utilisateurs primaires (c.à.d qu’ils sont prioritaires) dans les bandes 5250-5350 Mhz et 5650-5850 Mhz, ces radars peuvent causer des interférences et endommager les appareils réseaux LAN n’ayant pas obtenu de license.
Type
d’antenne
Gain en
2.4 GHz (dBi)
Gain en
5 GHz (dBi)
Connecteur
d’antenne
1 dipôle 2.6 3.7 R-SMA 2 dipôle 4.18 3.35 R-SMA 3 dipôle 2.99 4.43 R-SMA
Autres restrictions pour la bande 5600-5650 MHz: sauf avis contraire, les périphériques concernés par cette section ne doivent pas être capables de transmettre dans la bande 5600-5650 MHz afin de protéger les radars d’Environnement Canada qui l’utilisent.

Wireless Disclaimer

The maximum performance for wireless is derived from IEEE Standard 802.11 specifications. Actual performance can vary, including lower wireless network capacity, data throughput rate, range and coverage. Performance depends on many factors, conditions and variables, including distance from the access point, volume of network traffic, building materials and construction, operating system used, mix of wireless products used, interference and other adverse conditions.
2
Loading...
+ 8 hidden pages