Linear AM-KP Quick Start Manual
INTRODUCTION
1. AM-KP FEATURES
The AM-KP keypad is designed for use with Linear’s AE1000Plus,
AE2000Plus, and AM3Plus access control systems. The keypad is housed
in a rugged cast aluminum enclosure. The die-cast keys have bright, easyto-read yellow graphics. Each key has a positive tactile “click” feel when
pressed. An internal sounder signals when a key is pressed.
AM-KP
Access
Control
Keypad
Installation
Instructions
The keypad can be mounted to a pedestal or directly to a wall. A keylock
secures the keypad to the mounting backplate.
An incandescent panel lamp lights the keypad for nighttime use. Red, green
and yellow indicators show power, access and lockout conditions.
1
2
3
4
5
6
7
8
9
0
#
*
The AM-KP is normally powered from the controller, or can be powered
locally from a 12 VDC power supply. Robust static and lightning protection
circuits safeguard the keypad’s electronics.
A rotary switch selects the keypad’s PBUS device address. Each PBUS
device connected to the controller must be set to a different PBUS device
1
4
7
*
TACTILE
KEYPAD
2
5
8
0
address.
ADDRESS
SELECTOR
USA & Canada (800) 421-1587 & (800) 392-0123
(760) 438-7000 - Toll Free FAX (800) 468-1340
www.linearcorp.com
2. PLAN INSTALLATION 3. MOUNT BACKPLATE 4. ROUTE CABLE
PLAN THE LOCATIONS
FOR CONTROL AND
REMOTE DEVICES
PLAN CABLE RUNS
BETWEEN CONTROL
AND REMOTE DEVICES
PEDESTAL
AM-KP
ACCESS
KEYPADS
CARD
READERS
(USING AM-CRI
INTERFACE)
COMMERICAL
INSTALLATION
AM-KP
ON
LOBBY
ACCOUNTING
COMPUTER
ROOM
SERVICE
BATH
V.P.
APARTMENTS
APARTMENT GATE
INSTALLATION
CONTROLLER
ENGINEERING
BATH
SALES
V.P.
SALES
CONTROLLER
LAB
COPIER
AREA
PURCH.
CHIEF
ENG.
STOR.
PRESIDENT
PEDESTAL
WALL MOUNTING
USE CONCRETE
WEDGE ANCHORS
OR MOLLY ANCHORS
MOUNT BACKPLATE WITH
SECURITY BOLTS AND LOCKNUTS
HOMERUN WIRE
EACH KEYPAD
(1000 FEET WIRE MAXIMUM
ALLOWED IN SYSTEM)
EACH AM-KP KEYPAD EQUALS 9 LOAD UNITS
CABLE LENGTH FORMULA FOR EACH KEYPAD USED IN SYSTEM
CABLE RUN CABLE TYPE FORMULA
300 FEET MAXIMUM
500 FEET MAXIMUM
3
6
9
#
POWER/DATA
TERMINALS
PBUS
DEVICE
(1-6)
SOUNDER
KEYLOCK
BELDEN 9931 (24 AWG)
WEICO 9405 (20 AWG)
NIGHT LIGHT
YELLOW "LOCKOUT"
INDICATOR
RED/GREEN POWER/ACCESS
INDICATOR
FEET x LOAD UNITS < 3,000 MAXIMUM
FEET x LOAD UNITS < 10,000 MAXIMUM
5. CONNECT CABLE 6. SET PBUS DEVICE ADDRESS 7. SECURE & LOCK CASE
FOLLOW THIS WIRING DIAGRAM
TO CONNECT THE KEYPAD
TO THE CONTROLLER
USE A SMALL SCREWDRIVER
TO SET THE PBUS DEVICE ADDRESS SWITCH
PWR
GND
DAT1
DAT0
DVAL
PCLK
ACCESS CONTROL
SYSTEM PBUS
TERMINALS
EACH PBUS DEVICE
MUST BE SET TO A
UNIQUE NUMBER
FROM 1 TO 6
ARROW ON SLOT
POINTS TO NUMBER
HOOK KEYPAD
ONTO BACKPLATE
AM-KP
TERMINALS
PWR
GND
DAT1
DAT0
DVAL
PCLK
AM-KP
USE KEY TO
LOCK KEYPAD
FOR LOCAL POWER, DISCONNECT RED WIRE FROM "PWR" CONNECTION
ON AM-KP AND CONNECT EXTERNAL 12 VDC SUPPLY (+ TO PWR & - TO GND)
NOTE: CONTROLLER MUST BE CONNECTED TO AM-KP "GND"
8. PROGRAM SYSTEM 9. TEST KEYPAD LINEAR LIMITED WARRANTY
PROGRAM THE CONTROLLER
TO CONFIGURE THE REMOTE
RECEIVER
RED INDICATOR SHOULD
TURN GREEN AND PROGRAMMED
RELAY IN THE CONTROLLER
SHOULD ACTIVATE
1
2
3
4
5
6
7
8
9
0
#
*
This Linear product is warranted against defects in material and
workmanship for twelve (12) months. This warranty extends only
to wholesale customers who buy direct from Linear or through
Linear’s normal distribution channels. Linear does not warrant
this product to consumers. Consumers should inquire from their
selling dealer as to the nature of the dealer’s warranty, if any. There
are no obligations or liabilities on the part of Linear LLC for
consequential damages arising out of or in connection with use
or performance of this product or other indirect damages with
respect to loss of property, revenue, or profi t, or cost of removal,
installation, or reinstallation. All implied warranties, including
implied warranties for merchantability and implied warranties for
fi tness, are valid only until the warranty expires. This Linear LLC
Warranty is in lieu of all other warranties express or implied.
All products returned for warranty service require a Return Product
Authorization Number (RPA#). Contact Linear Technical Services at
1-800-421-1587 for an RPA# and other important details
REFER TO THE CONTROLLER
PROGRAMMING INSTRUCTIONS
FOR DETAILS
Copyright © 2012 Linear LLC 211560 E
Loading...