FDO VOICE BOARD W/ STROBE
90-FDOSV
Used on Fire Door Operators
INSTALLATION INSTRUCTIONS
INSTALLING NEW VOICE BOARD
1. Mount the new voice board to the electrical box
using the (4) #4-40 x 3/8” pan head screws supplied.
(Refer to figure one for board placement)
2. Connect the Black wire from the voice board to
#15 on the J2 terminal Block.
3. Connect the Red wire from the voice board to #19
on the J2 terminal Block
4. Connect the Yellow wire from the voice board to
#1 on the TB1 terminal Block
5. Connect the Purple wire from the voice board to
#2 on the TB1 terminal Block.
INSTALLING NEW SPEAKER
1. Choose a desirable position for the speaker and
mount using the hardware supplied.
2. Connect one wire from the speaker to #1 on the
TB1 terminal block and the other wire to #2 on the
TB1 terminal block.
TO AVOID SERIOUS PERSONAL INJURY OR
DEATH FROM ELECTROCUTION, DISCONNECT
ELECTRIC POWER TO OPERATOR BEFORE
INSTALLING.
APPLICATION REQUIREMENTS:
This modification is available to model FDO Fire Door Operators door operators.
FUNCTIONS:
Provides a Voice Board and Strobe to the standard operator.
INSTALLING NEW STROBE
1. Choose a desirable position for the strobe and
mount using the hardware supplied.
2. Connect the Red wire from the strobe to #17 on
the J2 terminal Block.
3. Connect the Black wire from the strobe to #15 on
the J2 terminal Block.
NOTE: Refer to the wiring diagram on page two for
help with wiring. Longer wires may be necessary to
wire the speaker and the strobe to the operator.
FIGURE 1
VOICE BOARD
PAN HEAD SCREWS
WARNING
© 2004, The Chamberlain Group, Inc.
01-15464C All Rights Reserved
VOICE BOARD W/ STROBE WIRING