ELECTRICALLY INTERLOCKED
CONTACT OR MODIFICATION
90-EI
APPLICATION REQUIREMENTS:
This modification is available to Model T, GT,J , H, GH, SD and GSD standard door operators
with 24V control circuits (M). It is not necessary on the single phase operators due to the
standard “IR Relay” circuit.
FUNCTIONS
Additional control circuit components are supplied with this modification to prevent the OPEN
coil of the reversing contactor from being electrically energized when the CLOSE coil is held in,
and vice versa.
of standard procedure, this modification is necessary only to meet certain stringent
architectural specifications, or where abuse of the operator at the control station may be
expected.
NOTE: Since the reversing contactor is mechanically interlocked as a matter
WIRING:
Refer to the wiring diagram supplied with the operator. If this diagram is missing, or you are
unsure of wiring requirements please call Technical Service @ 1-800-528-2806
01-13427A All Rights Reserved
© 1998, The Chamberlain Group, Inc.