Lift-master 909210MOCDE User Manual

To prevent possible SERIOUS INJURY or DEATH from electrocution, disconnect electric power to operator BEFORE installing.

ALL electrical connections MUST be made by a qualified

individual.

WARNING

APPLICATION

This wiring modification is available for models CT, CGT, CJ, CH, CGH, standard door operators and modification 65-9206 with Logic 3 (L3) control.

NOTE: Not available with Hazardous Area or Variable Speed Modifications.

FUNCTIONS

Each switch, or pole, provides a means to control auxiliary lights, heaters or other equipment. The switch can be used to turn on or off such equipment when the door is fully opened, fully closed or during travel.

COMPONENT MOUNTING

1. Disconnect power to operator.

2. Locate the new auxiliary limit switch bracket assembly with the limit switches attached. Loose end of limit arm on switch should face the side of electrical box (Figure 2).

3. Fasten the limit switch bracket to the component mounting plate at the bottom of the electrical box using the two #8-32 x 1/4" pan head screws provided (Figure 2).

4. Connect ends of wire leads to desired field wiring with wire nuts to complete installation (Figure 1).

5. Reconnect power to operator.

CARTON INVENTORY

DESCRIPTION QTY

Limit switch 2 Pan head screw #4-40 x 3/4" 4 Internal tooth lock washer 4 Limit switch backup plate 2 Limit switch nut plate 2 Limit switch mounting bracket 1 Pan Head screw #8-32 x 1/4" 2 White wire used with “OPEN” limit switch 16 Gauge, 24" 3 Blue wire used with “CLOSE” limit switch 16 Gauge, 24" 3

AUXILIARY LIMIT SWITCH

Mini Switches and Wire Leads

For Damp Environment Application

909210MOCDE and K909210M2DE

(C)

(NO)

(NC)

Auxiliary Open Limit Switch

(C)

(NO)

(NC)

Auxiliary Close Limit Switch

FIGURE 2

FIGURE 1

Pan Head Screws #4-40x3/4" (4 Pieces)

Limit Switch

Nut Plate

Auxiliary Switch Mounting Bracket

#4 Internal Tooth Lock Washer

Backup Plate (1 Per Switch)

Pan Head Screws #8-32 x 1/4" (2 Pieces)