Lift-master 88LM User Manual

Fasten the terminal blocks to the garage walls between the pre-wiring and the sensor unit locations as shown in Figure 1.
Figure 1
Model 88LM
©
Garage Door Opener
Pre-Wiring Kit
Drill Hole
Pre-Wiring
Pre-Wiring
5/32"
White
#6 Anchor
Terminal
Block
Terminal
Screws
Sensor
Unit
#6ABx1"
Screw
Sensor
Unit
Location
Approx.
18" Wire
PRE-WIRING FOR SAFETY SENSOR SYSTEM
2-Conductor Wire (white and white/black)
on each side of garage door, exiting wall
Figure 2 Figure 3
Sensor
Unit
White
Safety Sensor
White Tab
Sensor
Unit
Location
Approx.
18" Wire
White/Black
Separate and strip 1/4" of insulation from the 2-conductor wire exiting the wall on each side of the garage door. Insert a strand in two of the slots in the terminal block. Tighten the terminal screws.
White/Black
Terminal
Block
Sensor Wiring
(4 Ft.)
Connector
Insert the connector end of the bell wire supplied into the sensor and push until you hear a click. The white tab on the sensor should be flush with the back of the connector. Attach the other end of the wire to the ter­minal block following the procedure as described and shown in Figure 2.
© 1993, The Chamberlain Group, Inc.
114A1670 All Rights Reserved Printed in Mexico
Loading...