Lift-master 71LM User Manual

INDOOR/OUTDOOR LIGHT CONTROL - SERIES 71

The Indoor/Outdoor Light Control Is designed to operate only incandescent lamps of 150 Watts maximum. It can be used both indoors and outdoors in locations affording protection from direct exposure to rain. Please read the Instructions carefully to insure proper use

DO NOT INSTALL THE LIGHT CONTROL IN AN OUTDOOR LOCATION WHERE DIRECT EXPOSURE TO RAIN CAN OCCUR

1. The receiver code switch block is located under the rubber cover on upper rim of Control, as shown. Pry off cover and set aside until code is set.

4. Replace code switch cover on Control and snap in place. Reassemble transmitter.

NOTE: If two or more Light Products are installed, they must be located at least 10 feet apart to prevent electronic interference.

and maximum safety.

The Light Control Devices can be operated

________________________________________________________________________________________________________

Remove light bulb from the fixture. Screw top of Control into socket. Place washer over neck of bulb. Screw into bottom of Control, compressing washer slightly. Turn on any manual switch which would normally control the light and leave it in the ON POSITION. Press transmitter push button. Light should turn on. Press again and light will turn off.

NOTE: Allow a 1-second Interval between transmitter operations.

by any Series 50, 51, 52, 53 or 73 Transmitter.

SETTING OR CHANGING THE CODE

The Light Control receiver and transmitter which operates it must be set with matching codes. Be sure the Control is unscrewed from fixture before setting (or changing the code). Follow instructions below.

2. Remove transmitter cover screw. Carefully turn the case over (push button side up). Remove case top.

move circuit board components.

3. Set or change code in receiver and transmitter according to transmitter instruction sheet.

INSTALLATION AND OPERATION INSTRUCTIONS

CAUTION: Be careful not to

If light does not operate, check to to be sure:

1. All manual switches are turned on.

2. Control and lamp are firmly screwed in.

3. There is power to circuit (check fuse box or circuit breakers).

4. The bulb works.

If transmitter does not or operate, check to be sure:

1. Receiver and transmitter have matching codes.

2. You are pressing the push button selected to operate the Control (on 2-channel or 3-channel transmitter).

3. Transmitter battery has power. NOTE: Test light on the

transmitter should glow when push button is pressed.

_______________________________________________________________________________________________________

ACCESSORIES

Multifunction Remote Control

Series 53

Indoor/Outdoor Wire-in Light Control

Transmitter

NOTE: No user serviceable parts.

Series 72

Series 74

Plug-in Appliance/Ught Control

114A1055

 1988, The Chamberlain Group, Inc.

Printed in Mexico