Life Fitness 95Ti User Manual

Life Fitness Model 97Ti, 95Ti, 93T Treadmills

How To...Replace or Install Rear Roller Guards

Tools Required: Philips Screwdriver, Flat Blade Screwdriver

1. For either configuration, remove the ROLLER GUARDS by unscrewing the MOUNTING SCREWS as
shown.

Screw

Round Grommet

Washer

Square Grommet

Rear Roller
Guard, LF

Rear Roller
Guard, RT

Configuration 1

Roller Guard
Screw (4)

2. Using a flat blade screwdriver, remove the GROMMET
and WASHER.

3. Discard the WASHER.

Grommet

Roller Guard
Screw

Roller Guard,
(RT)

Low Profile
Grommet

Roller Guard Screw

Configuration 2

4. Reinstall the GROMMET.

NOTE: Use caution to prevent personal injury or
damage the to paint.

Washer Grommet

Re-install Grommet
w/o Washer

Life Fitness Model 97Ti, 95Ti, 93T Treadmills

How To...Replace or Install Rear Roller Guards

Tools Required: Philips Screwdriver, Flat Blade Screwdriver

5. Carefully remove the LOW PROFILE SQUARE
GROMMET from the bottom of the BASE FRAME.

(Configuration 1 Only)
CAUTION: Be careful not damage the LOW

PROFILE SQUARE GROMMET when removing it
from the BASE FRAME.

6. Reinstall the LOW PROFILE SQUARE GROMMET
back in the upper hole in the BASE FRAME.

(Configuration 1 Only)

7. Position the new ROLLER GUARD, which has a
larger, wider surface, under the STRIDING BELT.
Align the mounting holes and install the ROLLER
GUARD MOUNTING SCREWS.

8. Repeat STEPS 2 through 7 for the remaining
ROLLER GUARD. Upon completion, run the
treadmill and check for interference or binding. If
necessary realign the ROLLER GUARDS. Tighten
the MOUNTING SCREWS to 22-37 in lbs.

NOTE: After installation,
make sure the Roller
Guard in contact

IS NOT

with the Frame in this area.

M051-00K58-B128