Legrand ALTP User Manual

ALTP Tele-Power Pole
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 42521 – June 2003
Wiremold Electrical Systems conform to and should be installed and properly grounded in compliance with requirements of the current National Electrical Code, Canadian Electrical Code or codes administered by local authorities.
All electrical products may represent possible shock or fire hazard if improperly installed or used. Wiremold electrical products are UL Listed to U.S. and Canadian safety standards, made for interior use only, and should be installed in conformance with current local and/or the National Electrical Code.
The Wiremold Company
U.S. and International: 60 Woodlawn Street • West Hartford, CT 06110 1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251 Canada: 850 Gartshore Street • Fergus, Ontario N1M 2W8 1-800-741-7957 • FAX 519-843-5980
42521 – June 2003 – For latest specs visit www.wiremold.com
© Copyright 2003 The Wiremold Company All Rights Reserved
Step 1 Remove cover. Remove clamps
that hold in wireway. Withdraw wireway from pole – do not remove entrance end fitting.
Step 2 Determine length “A” to be
removed from pole. Fold wires back and cut length “A” from shown ends of cover, base, and wireway.
Step 3 To re-assemble – Replace
wireway into the base with conductors inside. Replace and tighten down clamps. Snap cover onto pole.
Cover
Wireway
Base
Clamp
Length
“A”
Clamp
Entrance
End Fitting
TO SHORTEN ALTP POWER POLE BEFORE INSTALLATION:
Length
“A”
Length
“A”
NOTE: Tele-Power Pole must extend above hanger clamp with Pole stanchion resting on floor.
Loading...