La Marzocco Modbar Pour-Over Pre-Installation Specifications
Pre-Installation Specifications
Modbar Pour-Over
Instructions for plumber, electrician, architect or
designer, outlining the specific requirements PRIOR TO
INSTALLATION of the Modbar Pour-Over System.
Prepare your site for the installation of one or more tap(s) and a drip tray(s) in the
countertop surface and one or more module(s) on a well-ventilated shelf or rack
directly below.
Designer or Architect Specifications — Above Counter
• A dry, well-ventilated counter area, which is between 32" and 38" high, with a
depth of at least 20".
• 1.5" and several smaller holes drilled through the countertop for each tap and
appropriate holes cut for each drip tray. Cuts should be made prior to the
installation using the Modbar Pour-Over layout template included with your
system.
7"
• If installing multiple taps, leave a minimum of 13 3/4" between center holes on
adjacent taps.
454mm
17 7/8"
6"
76mm / 3"
152mm / 6"
©2019 modbar llc. | 10 December 2019 | v.3.5Questions? Email La Marzocco Solutions at solutions.usa@lamarzocco.com or call (206) 706-9104 x101
Designer or Architect Specifications — Below Counter
• Cabinet space should have a depth of at least 20" and a width of at least 26" to
allow for clearance around and behind the modules.
• Shelves or a wire rack should be provided to support each module.
• Rear access to modules recommended whether through sliding doors or
• We do not recommend installing cabinet doors in this space.
• Cafe owner should consider where filtration will go. Water filtration is required
for all equipment.
• The maximum distance a tap can be installed away from the module is 5'.
removable panels.
Water Specifications
Your filtration system should produce water
with the following properties:
T.D.S. 90—150ppm
TOTAL HARDNESS 70—100 ppm
TOTAL IRON 0—0.02ppm
FREE CHLORINE 0—0.05ppm
TOTAL CHLORINE 0—0.1ppm
PH 6.5—8
ALKALINITY 40—80ppm
CHLORIDE 0—30ppm
LINE PRESSURE 35—70 PSI
FLOW RATE 2 GPM/8 LPM
Module Dimensions & Specifications
MODULE WIDTH
(+CLEARANCE)
Pour-Over 16" (+6") 14" (+6") 5.4" (+3", or 6") 30 lbs 208-240V NEMA 6-20R 3000
DEPTH
(+CLEARANCE)
HEIGHT
(+CLEARANCE)
WEIGHT VOLTAGE RECEPTACLE WATTAG E
Required Module Clearance
75mm / 3" min.
clearance
both sides
150mm / 6" min.
clearance
above
150mm / 6" min.
clearance
behind
150mm / 6"
75—150mm
3—6"
Questions? Email La Marzocco Solutions at solutions.usa@lamarzocco.com or call (206) 706-9104 x101 ©2019 modbar llc. | 10 December 2019 | v.3.5
Loading...