La Crosse Technology WS-9055U Instruction Manual

WS-9055U

Wireless 433 MHz

Weather Station

Instruction Manual

TABLE OF CONTENTS

Topic Page

Quick Setup 3-5
Inventory of Contents 6-7
Detailed Setup Guide

Battery Installation 7
Setting the Time 8

Features

Minimum and Maximum
Temperatures

Resetting Minimum and

Maximum Temperatures
Adding additional remote
temperature sensors
(optional)
Weather Forecast 12
Weather Icons 13-14

Tendency Arrow 14
Mounting 15-16
Troubleshooting 16-18
Maintenance and Care 18-19
Specifications 19-20
Warranty Information 21-26

9

10

10-11

2

QUICK SETUP

Hint: Use good quality Alkaline
Batteries and avoid rechargeable
batteries.

1. Have the indoor temperature station

and remote temperature sensor 3 to
5 feet apart.

2. Batteries should be out of both

units for 10 minutes.

3. Place the batteries into the remote

temperature sensor first then into

the indoor temperature station.
(All remote temperature sensors must be
started before the indoor temperature
station)

4. DO NOT PRESS ANY BUTTONS

FOR 15 MINUTES.

3

In this time the indoor temperature
station and remote temperature sensor
will start to talk to each other and the
display will show both the indoor
temperature and an outdoor temperature.
If the indoor temperature station does
not display both temperatures after the
15 minutes please retry the set up as
stated above. After both indoor and
outdoor temperatures are displayed for
15 minutes you can place your remote
temperature sensor outdoors and set
your time.

The remote temperature sensor should
be placed in a dry, shaded area. The
remote temperature sensor has a range
of 80 feet. Any walls that the signal
will have to pass through will reduce
distance. An outdoor wall or window
can have up to 30 feet of resistance and
an interior wall can have up to 20 feet of

4

resistance. Your distance plus
resistance should not exceed 80 ft. in a
straight line.
NOTE: Fog and mist will not harm
your remote temperature sensor but
direct rain must be avoided.

To complete the set up of your indoor
temperature station after the 15 minutes
have passed please follow the steps in
the detailed set up guide on page 8.

5

INVENTORY OF CONTENTS

1. The indoor weather station (Figure 1)

2. The remote temperature sensor (TX6U)

and mounting bracket. (Figure 2)

3. 3 each, 1/2” Philips screws.

4. One strip of double sided adhesive tape.

5. Instruction Manual and Warranty Card.

Figure 1

Figure 2

Holder

6

ADDITIONAL EQUIPMENT

(not included)

1. 1 Philips screwdriver.

2. 2 Fresh AA Alkaline batteries.

3. 2 Fresh AA Alkaline batteries

DETAILED SETUP GUIDE

Battery Installation

1. Install 2 AA

batteries in the

remote temperature

sensor. Make sure

they do not spring

free, or start-up

problems may

occur.

2.

Install 2 AA

batteries in

the indoor

weather

station. Do

not press any

buttons for at least fifteen minutes.

7

Setting the time

1. Press and hold the “SET” key for 4

seconds.

2. The hour will flash.

3. Press and release the “+” key to

advance the hour.

4. Press and release the “SET” key.

5. The minute is flashing.

6. Press and release the “+” key to

advance the minutes.

7. Press and release the “SET” key to exit

programming.

8