La Crosse Technology WS-9002U, WS-9002CAMO, WS-9002U User Manual

WS-9002U

Wireless 433 MHz

Temperature Station

Instruction Manual

1

TABLE OF CONTENTS

Topic Page

Inventory of Contents 3
Quick Setup 4-6
Detailed Setup Guide

Battery Installation 7-8

Features

Minimum and Maximum
Temperatures

Resetting Minimum and

Maximum Temperatures
Additional remote
temperature sensors
(optional)
Mounting 12-14
Troubleshooting 14-16
Maintenance and Care 16
Specifications 17-18
Warranty Information 19-23

9

9

10-12

2

INVENTORY OF CONTENTS

1.

The indoor temperature station (Figure

1)

2.

The remote temperature sensor (TX6U)
and mounting bracket. (Figure 2)

3.

3 each, 1/2” Philips screws.

4.

One strip of double sided adhesive tape.

5.

Instruction Manual and Warranty Card.

Figure 1

ADDITIONAL EQUIPMENT

(not included)

1.

1 Philips screwdriver.

2.

2 Fresh AAA 1.5V batteries.

3.

2 Fresh AA 1.5V batteries.

Figure 2

3

QUICK SETUP

Hint: Use good quality Alkaline
Batteries and avoid rechargeable
batteries.

1. Have the indoor

temperature station and
remote temperature sensor
3 to 5 feet apart.

2. Batteries should be out of

both units for 10 minutes.

3. Place the batteries into the

remote temperature
sensor first then into the

indoor temperature station.
(All remote temperature sensors must be
started before the indoor temperature
station)

4. DO NOT PRESS ANY

BUTTONS FOR 15

MINUTES.

4

In this time the indoor temperature
station and remote temperature sensor
will start to talk to each other and the
display will show both the indoor
temperature and an outdoor temperature.
If the indoor temperature station does
not display both temperatures after the
15 minutes please retry the set up as
stated above. After both indoor and
outdoor temperatures are displayed for
15 minutes you can place your remote
temperature sensor outdoors and set
your time.

The remote temperature sensor should
be placed in a dry, shaded area. The
remote temperature sensor has a range
of 80 feet. Any walls that the signal
will have to pass through will reduce
distance. An outdoor wall or window
will have up to 20 feet of resistance and
an interior wall will have up to 10 feet

5

of resistance. Your distance plus
resistance should not exceed 80 ft. in a
straight line.
NOTE: Fog and mist will not harm
your remote temperature sensor but
direct rain must be avoided.

6

DETAILED SETUP GUIDE

I.

BATTERY INSTALLATION

A.

REMOTE TEMPERATURE

SENSOR

1.

Remove the mounting bracket.

2.

Remove battery cover

3.

Observing the correct polarity, install
2 AA batteries—make sure they do not
spring free, or start-up problems may
occur. Replace cover.

7