La Crosse Technology 404-4525 Instructions

Warranty & Support
This product is warranted to be free from defects in material and workmanship under normal use and service for a period of 2 years from the date of sale to the customer. Warranty will not apply to defects resulting from abuse, accidents, or misuse. If a defect that is covered by this warranty arises during the warranty period, promptly return the clock (postage prepaid) with proof of purchase showing the date the clock was purchased to the following address and such defects will be repaired, or the products will be replaced at La Crosse Clock Company option without charge.
La Crosse Clock Company Warranty Department 2830 South 26th Street. La Crosse, WI 54601
www.lacrossetechnology.com/support
WARNING: This product can expose you to chemicals including styrene, which is known in the State of California to cause cancer. For more information go to: https://www.p65warnings.ca.gov/
10-Inch Night Vision
Wall Clock
Made in China - Printed in China
Model: 404-4525
DC: 110420
Power Up
Light Sensor
1. Insert 1 fresh AA, LR6 1.5 volt alkaline battery into the Movement, according to the polarity markings.
2. Insert 3 fresh AA, LR6 1.5 volt alkaline batteries into Night Vision Compartment, according to polarity. IMPORTANT: Be sure all batteries are of the same voltage level.
3. Rotate the Time Set Wheel to set the time.
4. Mount on your wall and enjoy!
Learn more from our video: bit.ly/wallclock_setup
Time Set Wheel
Movement
Night Vision
Compartment
Light Sensor ON/OFF Switch
Note: The quartz movement will keep the clock running accurately. If the clock does not operate, or steadily loses time, replace the battery.
There is a Light Sensor on the front of the clock. Light Sensor Switch ON: Your clock will light up in the dark providing the Night Vision. Light Sensor Switch OFF: Your clock will not light up at night to conserve batteries.
Specifications
Battery Requirements: 1 AA (IEC LR6) required in the Movement (Alkaline recommended) 3 AA (IEC LR6) required for the Light Sensor
Battery Life: 12 months
Care & Maintenance
• Always purchase the correct size and grade of batteries most suitable for intended use.
Do not mix old and new batteries.
Do not mix Alkaline, Lithium, standard, or rechargeable
batteries.
• Clean the battery contacts and also those of your clock prior to battery installation.
• Ensure the battery is installed with correct polarity (+ and -).
• Remove battery from equipment when it is not used for an extended period of time.
• Promptly remove an expired battery.
• The specs of this wall clock may change without prior notice.
• Improper use or unauthorized opening of housing voids the warranty.
Loading...