Kyocera FS-C8020MFP, FS-8025MFP, FS-C8025MFP, TASKalfa 2550ci SERVICEBULLETIN 2KZ 0026 C092 1

Currently, o

nly the rib (

A

) prevents the lever from coming off (Fig.1). The

Service Bulletin Ref. No.

Subject

(Revised Issue 1)

(Page.1/3)

2KZ-0026 (C092)

<Date> July 12, 2012

Measures against the Bypass Feed Failure (Prevention of
Coming-off of the DR-895C Solenoid Lever)

Model

This time, the description with (-->) was revised from the previous information.

<Number of changes: 2> The accurate serial numbers were added.

FS-C8020MFP, FS-C8025MFP, TASKalfa 2550ci

Topic

If excessive impact was applied to the DR-895C (Nos.1&2), the solenoid lever in the drive unit might come off. If it is
driven in this state, the solenoid lever cannot be engaged with the gears and the bypass lift plate will repeat lift-up
and lift-down motion, which might cause a paper feeding failure. Therefore, the following change was made.

Content of Changes

A rib was added to the housing side of the frame in order to prevent the solenoid lever from coming off.

[DR-895C (Nos.1&2)]

Solenoid mount side of frame

Housing side of frame

<OK> (Fig.1)

Lever Lever

Rib (A)

lever may come off on the housing side frame where it is not regulated
by the rib (A) (Fig.2). So, rib (B) was added to the housing side frame to
support the lever from both sides. (See the figure below for the position
where the rib (B) was added.)

<Cross-sectional view from X> (outline)

Rib added this time

X

Housing side frame

Rib added

<NG> (Fig.2)

Normal lever position

Lever position
when coming
off (dotted line)

Solenoid mount side
frame

KYOCERA Document Solutions Europe

Technical Customer Service Division (TCSD)

Q’

Com

bi

pati-

Service Bulletin Ref. No.

302K093141

1

302K09K141

2

Old Part

2K093141

2K09K141

No.

KMC’s Classification Entire Stock Rework In-Field modification at next visit

Field Measure:

Please check if the lever has come off when attaching the old type parts (No.1). (For more details, please see
below.) If it comes off, replace the part (No.1) with the new type one.
(Note) Do not open the drive unit to reseat the lever. Otherwise, the grease may adhere where it must not be
applied.

Serial Nos. of the Affected Machines: (-->) Please refer to the next page.

<Check if the solenoid lever comes off>

(Revised Issue 1)

(Page.2/3)

2KZ-0026 (C092)

<Date> July 12, 2012

ty

Old New Old New

lity

X O

X O

Lever comes off and is not
engaged with the gear.

Replace the DR-895C
(Nos.1&2) with new one.

Remarks

Except KDKR

For KDKR

No.

New Part

No.

302K093142

2K093142

302K09K142

2K09K142

Description

DR-895C 1 1

DR-895C(KR) 1 1

In-Field modification by case No modification necessary

(OK) (NG)

Lever and gear are engaged.

KYOCERA Document Solutions Europe

Technical Customer Service Division (TCSD)