Kyocera FS-C5150, FS-C2026, FS-5250, FS-2126MFP ServiceBulletin SQ-0095 [ENG ]

Service Tip Ref. No.

(Page.1/3)

SQ-0095

<Date> October 6, 2011

Subject Transfer of the Gear Wheel at Replacement of LK-590 / LK-591

Model

FS-C5150DN, FS-C5250DN, FS-C2026MFP, FS-C2126MFP,
FS-C2526MFP, FS-C2626MFP, FS-C2026MFP+, FS-C2126MFP+

Phenomenon

After the LK-590A (302KV93020) or LK-591A (302KT93020) was replaced, the belonging gear wheel is missing.
Respectively, after the LK-590B (302KV93030) or LK-591B (302KT93030) was replaced, the belonging gear wheels
for fine adjustment are missing.

Cause

The LK-590A and LK-591A are delivered without the belonging black gear wheel (for magenta adjustment).
The LK-590B and LK-591B as replacement parts are delivered without the belonging black gear wheels (for cyan
and yellow adjustment) for LK fine adjustment.

Measures

Before installation of a new LK-590A/ LK-591A, please remove the black gear wheel from the defective LK and
insert it into the new LK. Before installation of a new LK-590B/ LK-591B, please remove the both black gear wheels
from the defective LK and insert them into the new LK.

(Please refer to the photo “Bild_2_LK-590B_Inst_Zahnrad”.)

Please note that two guides each are fitted to the black gear wheel that must be inserted in the housing in the white
wheel on the opposite side.

(Please refer to the photo “Bild_3_EINKERBUNGEN_STELLRAD”.)

European Service & Development Center (ESDC)

KYOCERA MITA Europe B.V.

Service Tip Ref. No.

<Date> October 6, 2011

Bild_1_LK-590B_ohne_Zahnräder

(Page.2/3)

SQ-0095

Bild_2_LK-590B_Inst_Zahnrad

European Service & Development Center (ESDC)

KYOCERA MITA Europe B.V.