Kyocera FS-C5150, FS-5250 SERVICEBULLETINS 2KT 0004 B120
Q’
Com
bi
p
ati-
A
Hole of
the STAY
B
2mm
0mm
1mm gap
Service Bulletin Ref. No.
<Date> May 20, 2011
Subject Corrective Measures for C0150 Error
(Page.1/1)
2KT-0004 (B120)
Model
FS-C5150DN, FS-C5250DN
Topic
C0150 error may appear if the wire (EXIT-ENGN) is pinched by the rib on the COVER TOP P. Therefore, the
following changes made. C0150: Backup memory read/write error (engine PWB)
Content of Changes
A clamp (ACCESS.CLAMP (No.1)) was added to the path of the wire (EXIT-ENGN) to fix the wire.
Clamp added
No.
1
KMC’s Classification Entire Stock Rework In-Field modification at next visit
Field Measure:
When attaching the COVER TOP P, please pay attention so that the wire will not be pinched by the clamp.
Serial Nos. of the Affected Machines:
New clamp (ACCESS.CLAMP): From available timing in the April 2011* production
* The above is the plan at the present moment. Please note that this information is subject to change.
COVER TOP P
Enlarged
view of A
Old Part
No.
---------
The wire should not get over
the arrow mark side
ACCESSS.CLAMP
(N0.1)
Where to attach
ACCESSS.CLAMP
New Part
No.
7YZM390005++H01
YZ112220
In-Field modification by case No modification necessary
STAY REAR TOP
or more
From the edge of the hole of the STAY:
A
gap of
B The wire should not exceed the dotted line.
Description
ACCESS.CLAMP - 1
1 mm or more from the edge of the CLAMP
ty
Old New Old New
lity
- O
Remarks
European Service & Development Center (ESDC)
KYOCERA MITA Europe B.V.
Loading...