(Page.1/2)
Shape to prevent the developer
lock from being hooked
Shape Change of the Developer Unit Case
KDC’s Classification Entire Stock Rework In-Field modification at next visit
In-Field modification by case No modification necessary
Field Measures:
Please replace the developing unit with the new one after this change when the phenomenon described below
occurs. (Please distinguish the new unit by the serial number listed on the next page.)
Serial Nos. of the Affected Machines: Please refer to the next page.
(Bottom of the developer case)
<Positional relation between the notch and the developing lock>
(Following is the state of installing the developing unit in the machine)
Notch at the bottom of
the developing case
Developing lock
at the machine
If the developer lock may be hooked on the notch, the
release of the developer lock becomes unsmooth.
Service Bulletin Ref. No. 2J5-0023 (C345)
<Date> December 27, 2012
Topic
When installing the developing unit in the machine while shifting it rightwards, in a very rare case, the developer
lock at the machine side might not be able to be released if the notch at the bottom of the developer case is hooked,
and detachment of the developing unit might be hard. Therefore, the shape of the bottom of the developer case was
changed.
[Shape change of the developer case bottom]
(Old) (New)
(Note) The part number of the developer unit remains unchanged.
KYOCERA Document Solutions Europe
Technical Customer Service Division (TCSD)
(Page.2/2)
Service Bulletin Ref. No. 2J5-0023 (C345)
<Date> December 27, 2012
Serial Nos. of the Affected Machines/Units/MK Kits (FS-6950DN is currently not produced.)
KYOCERA Document Solutions Europe
Technical Customer Service Division (TCSD)