Kyocera FS-6025, FS-6030MFP Service Bulletin 2K3 014
Service Bulletin
SB Number:
Subject:
SB 2K3-014
Paper jam J9000 when feeding originals with the DP
Creation Date: 10/01/2012
Model: FS-6025MFP/6025MFP(B)/6030MFP, FS-C8020MFP/8025MFP
Phenomenon Paper jam J9000 (No original feed jam) may appear.
Cause When a high stack of originals is pushed with too much force, the Stopper which hold the
leading edge of the originals, adheres to the Seal at the Rib of the Top cover. When the DP
feed is started under this condition, the DP feed roller descends insufciently, resulting in
Paper jam J9000.
Solution The Seal which is afxed to the Rib at the Top cover (At the back of the Main body), has been
removed.
DP feed roller section
Top cover rib (Front
of the main body)
Top cover rib (Back
of the main body)
Top cover rib
Stopper
Original inserted
The DP feed roller descends and the
Stopper is separated from the Rib at the
Top cover.
Parts
X
Seal has been removed
Stopper
Before inserting the originals
The DP feed roller is lifted upwards ans the Stopper descends,
while the point marked as X at the Stopper, contacts the
Top cover.
(At the back of the Main
body only)
No. Old Parts
No.
1 303M894050
3M894050
KMIS Service Department, Kyocera Mita Europe B446 / SB 2K3-014
New Parts
No.
303M894051
3M894051
Description Q’TY Interchange-
ability
Old New Old New
PARTS COVER PF ASSY SP 1 1 X
Page 1 of 2
Service Bulletin
Classication
Field measure When the above mentioned phenomenon occurs, please remove the Seal, which is afxed to the
Serial numbers of affected machines
Type Serial number
FS-6025MFP/6025MFP(B)/6030MFP, FS-C8020MFP/8025MFP Not available
The above mentioned changes have been applied to machines produced after the above mentioned production date.
Normal operation Abnormal operation
Rib of the Top cover
Entire stock rework
Rib of the Top cover (At the back of the Main body). Do not remove the Seal at the front side of
the Main body, to ensure that the Stop function is not disabled.
In-eld modication at next visit
Rib of the Top cover
In-eld modication by case
X
No modication necessary
Stopper
Original
1. Set the Original.
2. The Drive starts and the DP feed roller descends.
3. The Stopper position is lowered as shown in the
image above and is separated from the Rib of the
Top cover. Now the Stopper can rotate.
Stack of Originals
Stopper
1. Set a high stack of Originals with to much force.
2. The Stopper and the Seal (Which is afxed to the
Rib of the Top cover) adhere to each other.
In this case, the Stopper is not separated from
the Rib, when the DP feed roller descends.
3. Under the above mentioned condition, the
DP feed roller does not descend, resulting in
Paper jam J9000 (No original feed jam)
KMIS Service Department, Kyocera Mita Europe B446 / SB 2K3-014
Page 2 of 2
Loading...