Kyocera FS-6025, FS-6030MFP Service Bulletin 2K3 007

Service Bulletin

SB Number:

Subject:

SB 2K3-007

Procedure when replacing the Main board (Error code C0180)

Creation Date: 22/06/2011

Model: FS-6025MFP/6025MFP(B)/6030MFP, FS-C8020MFP/8025MFP

Contents

The applicable models are not equipped with a Hard disk, therefore some data is saved at the Main board. Perform
the following procedure when replacing the Main board.

1. Perform Maintenance mode U004 to resolve machine number mismatch that appears after replacing the
Main board.

2. Adjust the Scanner image.

2.1. Input the value in the Auto scanner adjustment chart by using Maintenance mode U425.

2.2. Perform Maintenance mode U411 with the Auto scanner adjustment chart.

2.3. Perform [Halftone adjustment] at the System menu.

3. Reactivate the license for optional products, if these where installed.

3.1. Reactivate the ID card authentication kit B.

3.2. Register ID cards again by using Maintenance mode U222.

4. Import exported data from the machine, before replacing the Main board by using Maintenance mode U917.
Please note that exporting and importing of data is also possible by using the KM-Net Viewer.

5. Register the initial User and Fax settings at the System menu or the Command center.

6. Perform the below mentioned Maintenance modes if necessary.

No. Machine related maintenance mode No. Fax related maintenance mode

U250 Checking/clearing the maintenance cycle U603 Setting user data 1

U251 Checking/clearing the maintenance counter U604 Setting user data 2

U253 Switching between double and single counts U610 Setting system 1

U260 Selecting the timing for copy counting U611 Setting system 2

U326 Setting the black line cleaning indication U612 Setting system 3

U341 Specic paper feed location setting for printing function U615 Setting system 6

U343 Switching between duplex/simplex copy mode U625 Setting the transmission system 1

U345 Setting the value for maintenance due indication U695 FAX function customize

U402 Adjusting margins of image printing

U403 Adjusting margins for scanning an original on the contact glass

U404 Adjusting margins for scanning an original from the DP

U407 Adjusting the leading edge registration for memory image printing

U425 Setting the target

U429 Setting the offset for the color balance

U432 Setting the center offset for the exposure

U470 Setting the JPEG compression ratio

Classication

Field measure Please follow the above mentioned procedure, when replacing the Main board.

Entire stock rework

In-eld modication at next visit

In-eld modication by case

X

No modication necessary

Serial numbers of affected machines

Type Serial number

FS-6025MFP/6025MFP(B)/6030MFP, FS-C8020MFP/
8025MFP

KMIS Service Department, Kyocera Mita Europe B137 / SB 2K3-007

Not available, the above mentioned procedure is only for
the eld measure.

Page 1 of 1