Kyocera DF-710, DF-730 Service Bulletin 3JY 002
Service Bulletin
SB Number:
SB 3JY-002
Creation Date: 01/06/2007
Subject: Firmware change, new model compatibility chart
Model:
The F/W is changed to support the new models, specically the KM-C4035E.
NOTE:
The below table describes the compatibility between current and new machines/accessories. It becomes clear that only the new DF-710/730 and
DP-710 are compatible with the new KM-C4035E. The new DF/DP models are compatible with all the current and new colour MFP’s, whereas the
current DF/DP rnage will cover all but one model; the KM-C4035E.
Main body to
which it can be
installed
Label on the
outer carton
Item code:
DF-710/730, DP-710
Compatible with present model Support for new model
KM-C2520/C3225/C3232
KM-C2525E/C3232E
DF-710 DF-730 DP-710 DF-710 DF-730 DP-710
1203JY0UN0 1205H10UN0 1203J90KL0 1203JY0U10 1205H10U10 1203J90K10
KM-C2520/C3225/C3232
KM-C2525E/C3232E/C4035E
Related part information
Interc
No. Old part number New part number Description
1 303JY01022 303JY01023 MIDDLE PWB ASS’Y 1 1 X O F/W VER. 3JY_9600.004.002
2 303JY80014 303JY80015
3 303J901011 303J901012 DRIVER PWB ASS’Y 1 1 X O F/W VER. 3J9_9500.004.005
4 305H180020 TBA PBA-CONT-F 1 1 X O F/W VER. 5H1_9200.002.007
MAIN PWB ASS’Y
WITH SOFTWARE SP
Q’ty
Old New Old New
1 1 X O F/W VER. 3JY_9200.006.003
abi
hange
lity
Remarks
Contents of change in rmware
Model
DF-710
DF-730
1
DP-710
2 DF-710 The timing of paper
3 DF-710 Measure against JAM 88
Item
Support for new model
(KM-C4035E)
holding solenoid has been
adjusted
occurring due to 3 sheets
monochrome A4 & 2
staples (JAM88: Main tray
eject JAM)
Contents
Changed to support cycle speed of the KM-C4035E
In order to reduce the sound of the paper holding lever hitting the main tray, the
operation timing of the paper holding solenoid has been changed as follows
There might be the possibility that JAM88 might occur when copying 3 sheets
Monochrome A4 copy & 2 staples continuously. Therefore, it is corrected.
4 DP-710 The paper feeding timing
at Auto Selection mode
has been changed.
KMIS Service Team, Kyocera Mita Europe 8095 / SB 3JY-002
On the Auto Selection mode, there is a possibility that small size original is detected
as large size original and paper is output with half of the image printed on large
sized paper. Therefore, it is corrected.
Loading...