Kymco MO MXU250 Service Manual - chap06 (rimozione motore)
6. ENGINE REMOVAL
MXU 250
6
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
ENGINE REMOVAL
__________________________________________________________________________________
SERVICE INFORMATION------------------------------------------------ 6- 1
ENGINE REMOVAL ------------------------------------------------------- 6- 2
6
6-0
6. ENGINE REMOVAL/INSTALLATION
MXU 250
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• A floor jack or other adjustable support is required to support and maneuver the engine.
Be careful not to damage the machine body, cables and wires during engine removal.
• Use shop towels to protect the machine body during engine removal.
• Parts requiring engine removal for servicing:
⎯ Crankcase
⎯ Crankshaft
6-1
6. ENGINE REMOVAL
t
t
ENGINE REMOVAL
Drain engine oil and transmission oil.
(Refer to chapter 3).
Remove frame covers and exhaust pipe.
(Refer chapter 2).
Remove the air cleaner housing and
carburetor. (Refer to chapter 5).
Remove the secondary air cleaner (refer to
chapter 20).
Remove the spark coil (refer to chapter 17).
Disconnect the crankcase breather from the
cylinder head cover.
MXU 250
Breather Hose
Disconnect the water hose from water pump
cover.
Remove the bolt at the thermostat and
disconnect the thermosensor wire, then
disconnect the thermostat from the cylinder
head.
Water Hose
Thermosta
Bol
Thermosensor Wire
6-2
Loading...