Kymco MO MXU250 Service Manual - chap02 (plastiche e marmitta)

2. FRAME COVERS/EXHAUST MUFFLER
MXU 250
2
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
FRAME COVERS/EXHAUST MUFFLER
__________________________________________________________________________________
SERVICE INFORMATION------------------------------------------------ 2- 2 TROUBLESHOOTING----------------------------------------------------- 2- 2
2
FRAME COVERS----------------------------------------------------------- 2- 3 EXHAUST MUFFLER REMOVAL-------------------------------------- 2-11
2-0
2. FRAME COVERS/EXHAUST MUFFLER
MXU 250
2-1
2. FRAME COVERS/EXHAUST MUFFLER
MXU 250
SERVICE INFORMATION
GENERAL INSTRUCTIONS
When removing frame covers, use special care not to pull them by force because the cover joint claws may be damaged.
Make sure to route cables and harnesses according to the Cable & Harness Routing.
TORQUE VALUES
Exhaust muffler lock bolt 3.2~3.8kgf-m (32 ~ 38Nm, 23 ~ 27.4ft-lb) Exhaust muffler lock nut 1.8~2.2kgf-m (18 ~ 22Nm, 13 ~ 15.8 ft-lb)
TROUBLESHOOTING
Noisy exhaust muffler
Damaged exhaust muffler
Exhaust muffler joint air leaks
Lack of power
Caved exhaust muffler
Exhaust muffler air leaks
Clogged exhaust muffler
2-2
2. FRAME COVERS/EXHAUST MUFFLER
t
r
r
FRAME COVERS
SEAT
REMOVAL Pull the lever right and pull up the seat at the rear. Remove the seat.
MXU 250
Leve
INSTALLATION To install the seat, align the tabs on the seat
with the grommets on the frame and press the seat down until it locks.
FRONT CARGO RACK
REMOVAL/INSTALLATION Remove the two mounting bolts and two bolts under front fender
Sea
Frame RightCove
Bolts
.
Mounting Bolts
2-3
Loading...
+ 8 hidden pages