KOHLER K-977, K-368, K-424, K-10573 Installation Manual

KOHLER K-977, K-368, K-424, K-10573 Installation Manual

Installation Guide

Deckor Bath-Mount Handshower Holder with Hoses

K-368

 

K-424

K-977

 

K-10573

M product numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

M corresponden a México (Ej.

K-12345M)

Français, page ªFrançais-1º

Español, página ªEspañol-1º

1041355-2-C

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before you start installation. If you encounter any installation or performance problems, please don't hesitate to contact us. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler Company.

Tools and Materials

Adjustable Wrench

Tape Measure

Drill

1-1/4" Drill Bit

Before You Begin

Please read all instructions before you begin.

Observe all local plumbing and building codes.

Shut off the main water supply.

Provide an access panel for all installations.

Carefully inspect waste and supply tubing for any sign of damage. Replace if needed.

NOTE: Plumbing codes may require a vacuum breaker be installed in-line to handshowers. Please consult with local plumbing codes. If a vacuum breaker is required, ensure that it is not installed between the handshower high pressure and interlock hoses.

Kohler Co. reserves the right to make revisions in the design of products without notice, as speci®ed in the Price Book.

1041355-2-C

2

Kohler Co.

Handshower Handle

Screen Washer

Handshower Holder

Fiber Washer

Fiber Washer

Hose Guide

Flexible Hose

Flexible Hose

WasherWasher

High Pressure Hose

Water Source

1. Install the Handshower

From the top of the bath or ®nished deck, insert the smaller end of the ¯exible hose down through the hose guide.

From the underside of the bath or ®nished deck, insert one washer into the ¯exible hose.

Thread the ¯exible hose into the high pressure hose.

Insert one washer into the other end of the high pressure hose.

Connect the high pressure hose onto a vacuum breaker (if installed), or to the appropriate water source.

Run cold and hot water through the hoses to ¯ush out dirt and debris.

Check for leaks.

Turn the cold and hot water valves off.

Insert the two ®ber washers into the end of the ¯exible hose.

Thread the handshower holder onto the ¯exible hose.

Insert the screen washer into the end of the handshower holder.

Kohler Co.

3

1041355-2-C

Install the Handshower (cont.)

Thread the handshower handle into the handshower holder.

To avoid kinking, remove any twists or loops in the hose.

2. Installation Checkout

Complete the installation of the valve, valve trim and any other components according to the instructions packed with the product.

Ensure all connections are tight.

Open the drain.

Turn on the main water supply and check for leaks above and below the bath or ®nished deck. Repair as needed.

Open both hot and cold valves and run water through the spout (if installed) to remove debris. Check for leaks.

Check the handshower for smooth operation.

Con®rm proper diverter operation.

Turn the valves to the closed position.

1041355-2-C

4

Kohler Co.

Guide d'installation

Support de la douchette avec des ¯exibles sur baignoire/comptoir

Outils et matériels

Clé à molette

Mètre ruban

Perceuse

Mèche de 1-1/4"

Merci d'avoir choisi la compagnie Kohler

Nous apprécions votre engagement envers la qualité Kohler. Veuillez prendre s'il vous plaît quelques minutes pour lire ce manuel avant de commencer l'installation. Ne pas hésiter à nous contacter en cas de problème d'installation ou de performance. Nos numéros de téléphone et notre adresse du site internet sont au verso. Merci encore d'avoir choisi la compagnie Kohler.

Avant de commencer

Veuillez lire toutes les instructions avant de commencer.

Respecter tous les codes de plomberie et de bâtiment locaux.

Couper l'alimentation d'eau principale.

Prévoir un panneau d'accès pour toutes les installations.

Véri®er avec soin si l'évacuation ou les tubes d'alimentation sont endommagés. Remplacer si nécessaire.

REMARQUE : Les codes de plomberie peuvent requérir l'installation en ligne d'un reni¯ard aux douchettes. Veuiller consulter les codes

Kohler Co.

Français-1

1041355-2-C

Loading...
+ 11 hidden pages