Knight Equipment DC-I User Manual
MODEL PART # DESCRIPTION
DC-I 7659101 SYSTEM W/ONE 3GPM AIR OPERATED
PUMP. PRESSURE REGULATOR W/FILTER
DRYER, PLASTIC ROTATIONAL MOLDED
WATERTIGHT CASE AND STAINLESS STEEL
MOUNTING BRACKETS.
DC-IS 7659103 SYSTEM W/ONE 3 GPM AIR OPERATED
PUMP W/AIR SOLENOID. PRESSURE
REGULATOR W/FILTER DRYER, PLASTIC
ROTATIONAL MOLDED WATERTIGHT CASE
AND STAINLESS STEEL MOUNTING BRACKETS.
24 VAC SOLENOID VALVE, 115 TO 24 VCD
POWER SUPPLY.
**Requires vacuum switch assembly
DC-II 7659601 SYSTEM W/TWO 3 GPM AIR OPERATED
PUMP. THREE WAY VALVE PUMP SELECTOR.
PRESSURE REGULATOR W/FILTER
DRYER, STAINLESS STEEL WATERTIGHT CASE
AND STAINLESS STEEL MOUNTING BRACKETS.
DC-IIS 7659602 SYSTEM W/TWO 3 GPM AIR OPERATED
PUMP W/AIR SOLENOID. THREE WAY VALVE
PUMP SELECTOR. PRESSURE REGULATOR
W/FILTER DRYER, STAINLESS STEEL WATER
TIGHT CASE AND STAINLESS STEEL
MOUNTING BRACKETS.
**Requires vacuum switch assembly
TDVS 7659502 VACUUM SWITCH ASSEMBLY
SINGLE PUMP SYSTEM
The Knight Dairy-Chem single pump teat dip dispenser offers two efficient models – DC-I and DCIS. The standard DC-I model is powered by compressed air and plumbs directly to an onsite air
supply line. The DC-IS model comes with an air
solenoid valve and a 24VAC transformer. When
connected to a teat dip vacuum switch, this system can power-on and power-off with vacuum
from the pipeline.
DUAL PUMP SYSTEM
The dual pump system is capable of dispensing
teat dip products to two areas in the milking
parlor or it can also be employed as a redundant
system with built-in “backup” pump that guarantees 100% uptime performance.
TEAT DIP CHEMICAL DISPENSER
Dairy-Chem DC-I
Dairy-Chem DC-II
DC-I without solenoid
DC-IS with solenoid
DC-IIS with solenoid
DC-II without solenoid
Loading...