INSTRUCTION SHEET
for Water Softener Tank Kit
Kit Contains:
(1)Softener Tank
(2)Nut - Tank
(1) Flow Meter
(1) Gasket
(1) Nut - Inlet
(1) Instruction Sheet
WARNING
Electrical Shock Hazard Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Unplug dishwasher or disconnect power.
2.Pull the dishwasher away from the wall, being sure to cover the floor with cardboard or hardboard to avoid floor damage.
3.Insert the handles of a pair of pliers into the water inlet nut and then turn counter clockwise to remove. See Figure 1.
waterinlet nut
Figure1
4.Remove the cap to the water softener tank and place the 2 ½ inch socket referenced in your dishwasher parts list over the nut on the water softener tank. Hold the socket firmly in place turn the socket counter clockwise to loosen the nut.
NOTE: Do not remove the nut. See Figure 2.
socket
5.Lay the dishwasher on its back. Disconnect the wire from the flow meter on the water softener tank. See Figure 3.
Flowmeter
connector
Figure3
6.Remove the hoses from the water softener tank. See Figure 4.
Hoses
watersoftener tank
Figure4
7.Remove the nut to the water softener tank loosened in Step 4, and remove the tank from the dishwasher.
Figure2 |
(continued) |
|
Instruction Sheet W10424609 Rev. A 06/11 |
— 1 — |