KitchenAid KESS908S, KERS807S User Manual

30" Freestanding and Slide-In Electric Range

®

PRODUCT MODEL NUMBERS OVERALL DIMENSIONS

CABINET OPENING DIMENSIONS

SLIDE-IN RANGE
COUNTERTOP PREPARATION

KERS807S
KESS908S

Electrical: When a 4-wire or 3-wire,
single phase 120/240-volt, 60 Hz, AC-only
electrical supply is available, a 50 amp
maximum circuit protection is required (or,
if specified on the model/serial rating
plate, when a 4-wire or 3-wire single
phase 120/208-volt 60 Hz, AC-only
electrical supply is available, a 40 amp
maximum circuit protection is required),
fused on both sides of the line. The
model/serial number rating plate is located
on the oven frame behind the storage
drawer panel. A time-delay fuse or circuit
breaker is recommended.

Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

The cooktop sides of the slide-in range fit over the
cutout edge of your countertop.

If you have a square finish (flat) countertop and the
opening width is 30" (76.2 cm), no countertop
preparation is required.

Formed front-edged countertops: Must have
molded edge shaved flat 3/8" (1.0 cm) from each
front corner of opening.

Tile countertops may need trim cut back
3/8" (1.0 cm) from each front corner and/or
rounded edge flattened.

If countertop opening width is greater than 30"
(76.2 cm), adjust the 3/8" (1.0 cm) dimension.

Countertop must be level. Place level on
countertop, first side to side; then front to back. If
countertop is not level, range will not be level.
Range must be level for satisfactory baking
performance.

Ref. 9763461

08-08-06

Cabinet opening dimensions shown are for
25” (64 cm) countertop depth, 24” (61 cm)
base cabinet depth and 36” (91.4 cm)
countertop height.

NOTE: 24" (61 cm) min. when bottom of wood or metal
cabinet is protected by not less than 1/4" (0.64 cm)
flame retardant millboard covered with not less than
No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel,

0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) min. clearance between the top of the
cooking platform and the bottom of an unprotected wood
or metal cabinet.

If installing a range hood or microwave hood
combination above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.

C

Freestanding Range

B

A

D*

C

G

F**

A. 5³⁄₄" (14.6 cm)
B. 30" (76.2 cm)
C. 41³⁄₄" (106 cm) overall

height with leveling legs
screwed all the way in

D. 36" (91.4 cm) cooktop trim

height with leveling legs
screwed all the way in*

*Range can be raised ap proximately 1" (2.5 cm) by adjusting

the leveling legs.

**When install ed in a 24" (61 cm) base cabinet with 25" (63.5 cm)

countertop; front of oven door protrudes 1" (2.5 cm) beyond
24" (61 cm) base cabinet.

E

E. 30" (76.2 cm)
F. 27 ¹⁄₄" (69.2 cm) max. from

handle to standoff at back of
range**

G. Model/serial number plate

(located on the right-hand side
oven door trim)

Slide-in Range

A

F

B*

E**

A. 30¹¹⁄₁₆" (77.6 cm)
B. 35⁵⁄₈" (90.5 cm) height to

underside of cooktop edge
with leveling legs screwed all
the way in*

C. Model/serial number plate

(located on the right-hand side
oven door trim)

*Range can be raised approximat ely 1" (2.5 cm) by adjusting

the leveling legs.

**When installed in a 2 4" (61 cm) base cabinet with 25" (63.5 cm)

countertop; front of oven door protrudes 1³⁄₄" (4.4 cm) beyond
24" (61 cm) base cabinet.

D

D 30" (76.2 cm)
E. 27¼" (69.2 cm) from handle

to standoff at back of
range**

F. 23" (58.4 cm) countertop

notch to rear of cooktop

30"

(76.2 cm)

30 ³⁄₄"

(78.1 cm)

³⁄₈"

(1.0 cm)

13" (33 cm)

upper cabinet

18" (45.7 cm) upper
cabinet to countertop

4" (10.2 cm) min.
clearance from
both sides of
range to side
wall or other
combustible
material

Junction box - 8"

(20.3 cm) to 22" (55.9 cm)

from either cabinet, 7"

(17.8 cm) max. from floor

egnaR gnidnatseerF

depth

30" (76.2 cm) min.

opening width

30"

(76.2 cm) min.

opening width

Cabinet door

or hinge
should not
extend into
the cutout.

For minimum

clearance to the

top of the cooktop,

see NOTE*.

18" (45.7 cm) upper
cabinet to countertop

4" (10.2 cm) min.
clearance from
both sides of
range to side
wall or other
combustible
material

Junction box - 8"

(20.3 cm) to 22" (55.9 cm)

from either cabinet, 7"

(17.8 cm) max. from floor

13" (33 cm)

upper cabinet

depth

30" (76.2 cm) min.

opening width

(6.2 cm) radius

both corners

C

1/4"

(76.2 cm) min.

opening width

Cabinet door

or hinge
should not
extend into

the cutout.

egnaR ni-edilS

For minimum

clearance to the

top of the cooktop,

see NOTE*.

22 3/4" (57.8 cm)

opening depth

30"