Keurig K-compact User Manual

K-COMPACT

Use & Care Guide

Get the most from your
new Keurig® brewer

™

Before You Brew

1

Remove packing tape from
brewer and plug into a
grounded outlet.

Place a large mug (10 oz.
minimum) on the drip tray
plate.

3 4

Press power button—the green power
light will illuminate.

The brewer will automatically begin
heating the water. This will take about 4
minutes. Once the heating sound stops,
the brewer is ready.

Plug & Place

Power On

Add Water

2

Remove the water reservoir lid, then lift
the reservoir straight up to remove it.

Rinse reservoir with fresh water and fill
to the MAX line.

Replace water reservoir, making sure
the lock tabs engage with the brewer.
Replace lid.

NOTE: Do not use distilled water.

Rinse & Fill

Lift & Lower

Lift and lower the handle. Do not insert
a K-Cup® pod. The three brew buttons

will blink.

Press the small cup button to start a
cleansing brew. Pour the hot water into
the sink.

The one-time setup process is now
complete and you are ready to brew!

Brew Your First Cup

5

Place a mug on the drip tray plate. If
using a travel mug, remove the drip tray
and place the mug on the drip tray base.

NOTE: Between brew cycles, the brewer may take about a minute to reheat.

Select your brew size. The button will
remain illuminated while brewing—about
1 minute. Brewing ends with a burst of air.
Lift the handle and dispose of the used
K-Cup® pod. The brewer will be ready to
brew another cup in about a minute.

NOTE: After 60 seconds, the brew buttons will be disabled. To re-activate,

lift and lower the handle completely.

CAUTION: While brewing, there is extremely hot water in the K-Cup® pod
holder. To avoid injury, do not lift the handle during the brewing process.

Place Mug

Brew & Enjoy

7

Large Mug
10 oz.

Small Mug
8 oz.

Small Cup
6 oz.

6

place a K-Cup® pod in the K-Cup®
pod holder. Lower the handle
completely to close the lid.

Do not remove the foil lid on the
K-Cup® pod.

Lift & Insert

Lift the handle and

Brewer Features

Smart Start heats then brews in one

simple process. No need to wait for the
brewer to heat before selecting brew size.
Power on your brewer, place mug, insert a
K-Cup® pod, and lower the handle. Then,
select your brew size. The brewer will
heat, then automatically begin brewing.

Auto Off automatically turns your brewer
off 2 hours after the last brew for energy
savings.