K-mini Plus
Use & Care Guide
K•Mini Plus
™
Get the most from your
®
new Keurig
brewer
Before You Brew
Brew Button
Brew Button
STRONG Button
Plug & Power Fill & Place
1
2
Remove packing tape from brewer.
Pull plug and extend cord from cord
storage located at the back of the
brewer. Plug into a grounded outlet.
Press the power button. The power
button will illuminate.
Lift & Lower Cleansing Brew
3
Lift and lower the handle. Do not
insert a K-Cup® pod. The brew
indicator light will flash to indicate
that the brewer is ready.
Add 1 cup (8oz) of water into
a mug. Lift the water reservoir
lid and pour the water into the
reservoir. Do not fill past the MAX
or below the MIN fill lines. Lower
the lid and place your mug on the
drip tray.
NOTE: Do not use distilled water.
4
STRONG
Press the brew button. The brew
indicator light will illuminate solid,
then begin to pulse while the brewer
is heating. After about 2 minutes, the
brew indicator light will illuminate
solid again and the water will begin
to dispense. Pour the hot water into
the sink.
The one-time setup process is now
complete and you are ready to brew!
Brew Your First Cup
Fill & Place Mug
5
Add desired amount of water
into a mug (6oz minimum, 12oz
maximum). Lift the water reservoir
lid and pour the water into the
reservoir. Do not fill past the MAX or
below the MIN fill lines. Lower the lid
and place your mug on the drip tray.
Brew & Enjoy!
7
Press the brew button - for bolder
coffee, press the STRONG button
before pressing the brew button. The
brew indicator light will illuminate
solid, then begin to pulse while the
brewer is heating. After about 2
minutes, the brew indicator light
will illuminate solid again and the
beverage will begin to dispense.
Brewing is complete when the brew
indicator light is no longer illuminated. When complete,
lift the handle and dispose of the used K-Cup® pod.
CAUTION: While brewing, there is extremely hot water in the K-Cup® pod holder. To avoid injury, do
not lift the handle during the brewing process.
Lift & Place Pod
6
Lift the handle. Place a K-Cup® pod in
the K-Cup® pod holder. Lower the handle
completely to close the lid. The brew
indicator light will flash to indicate that
the brewer is ready. Do not remove the
foil lid on the K-Cup® pod.
High Altitude Brewing: While holding the brewer
handle up, push down slowly on the K-Cup® pod
in the pod holder until the bottom of the
K-Cup® pod is punctured by the exit needle.
STRONG
Brewer Features
Strong Brew increases your coffee strength and intensity. For bolder coffee
press the STRONG button.
Pod Storage holds 9 K-Cup
space.
Removable Water Reservoir for easy cleaning and filling.
Auto Off: Automatically turns your brewer off 90 seconds after the last brew
for energy savings.
Cord Storage: Makes transporting your brewer convenient and keeps
countertops tidy.
Travel Mug Friendly: Remove the drip tray to accomodate a travel mug.
®
pods and fits in your brewer to save counter
Loading...