Kenwood KCA-RC50MR User Manual

KCA-RC50MR

Marine Remote Control
Installation Instructions

Mounting The Remote Control:

1. Select a mounting location that is flat and 1/2” thick or less.

2. Using the supplied rubber gasket as a template, drill the mounting holes and a hole for the wiring
at the desired locations.

3. Mount the remote control according to the diagram in FIG. 1 using supplied hardware.

4. Connect the electrical wiring for power, illumination, and ground as shown in FIG. 1.
Connect supplied data line to remote, route to the radio and connect to the connector on the
rear of the radio as shown in FIG. 2.

2 AMP FUSE

RED + 12V switched/ignition

YELLOW Illumination (connect to instrument lighting)

BLACK: ground

BLUE Data line (connect to radio)

NUT

LOCK WASHER

WASHER

MOUNT ING SURFACE

GASKET

REMOTE

Data Line Connection
Point:

Note, The rear view of radio and location
of connection point will vary dependent
on radio model.

FIG. 1

FIG. 2