Intermec 751G, CK31, CK31G, CK61, CK61G Instructions Manual

Use the dust cover to protect the Intermec computer keypad

Dust Cover Instructions

from dust, dirt, and rain. The clear material of the dust cover
allows you to use the touch screen and the keypad with the dust
cover installed. You cannot install a dust cover if you are using a
serial adapter, CAC reader, or holster accessory.

Note: Remove the dust cover before inserting your
computer into a charging or communications dock.

To install the dust cover

1 If you have a CK31G, CN2, or 751G, remove the serial port

cover.

2 Insert the top of the CK31, CK31G, CN2, 751G, or CK61G

into the dust cover.

3 Pull the dust cover over the bottom of the handheld

computer.

A

Installing the Dust Cover: Each Intermec computer has a unique dust
cover made specifically for it. This illustration shows the CK31 with a
52-key keypad dust cover for reference.

B

4 If necessary, install the serial port cover on your computer.

Dust cover

Dust cover

Dust cover

CK31 serial port
cover (CK31G only)

CN2 serial
port cover

751G serial
port cover

Installing the Serial Port Cover

Note: On the CK61G you may also need to insert the
head phone plug into the jack as shown in the
following illustration.

Installing the Head Phone Plug

Headphone
jack

Dust Cover Instructions

Worldwide Headquarters

6001 36th Avenue West
Everett, Washington 98203
U.S.A.

tel [phone]
fax [phone]

www.intermec.com

©

2007 Intermec Technologies

Corporation. All rights reserved.

*074130-003*

P/N 074130-003