Intel BXNUC10I3FNHFA3 User Manual

User Guide for NUC10i7FNH, NUC10i5FNH, NUC10i3FNH

1

Intel® NUC Kit NUC10i7FNH
Intel® NUC Kit NUC10i5FNH
Intel® NUC Kit NUC10i3FNH

User Guide

User Guide for NUC10i7FNH, NUC10i5FNH, NUC10i3FNH

2

Before You Begin

CAUTIONS

The steps in this guide assume you’re familiar with computer terminology and with the safety
practices and regulatory compliance required for using and modifying computer equipment.

Disconnect the computer from its power source and from any network before performing any of the steps
described in this guide.

Failure to disconnect power, telecommunications links, or networks before you open the computer or
perform any procedures can result in personal injury or equipment damage. Some circuitry on the board
can continue to operate even though the front panel power button is off.

Follow these guidelines before you begin:

• Always follow the steps in each procedure in the correct order.

• Create a log to record information about your computer, such as model, serial numbers,

installed options, and configuration information.

• Electrostatic discharge (ESD) can damage components. Perform the procedures described in

this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam
pad. If such a station isn’t available, you can provide some ESD protection by wearing an
antistatic wrist strap and attaching it to a metal part of the computer chassis.

Installation Precautions

When you install and test the Intel NUC, observe all warnings and cautions in the installation
instructions.

To avoid injury, be careful of:

• Sharp pins on connectors

• Sharp pins on circuit boards

• Rough edges and sharp corners on the chassis

• Hot components (such as SSDs, processors, voltage regulators, and heat sinks)

• Damage to wires that could cause a short circuit

Observe all warnings and cautions that instruct you to refer computer servicing to qualified
technical personnel.

Observe Safety and Regulatory Requirements

If you don’t follow these instructions, you increase your safety risk and the possibility of noncompliance
with regional laws and regulations.

User Guide for NUC10i7FNH, NUC10i5FNH, NUC10i3FNH

3

This guide tells you how to:

• Install and remove memory

• Install an M.2 SSD

• Install a 2.5” drive

• Install a VESA mount bracket

• Connect power

• Install an operating system

• Install the latest drivers

Open the Chassis

To open the Intel NUC chassis, follow these steps:

1. Unscrew the four corner screws on the bottom cover of the chassis and lift the cover.

Installing and Removing Memory

Intel NUC Kits NUC10i7FNH, NUC10i5FNH, and NUC10i3FNH have two 260-pin DDR4 SO-DIMM sockets.
Be sure to select memory modules that meet these requirements:

• 1.2V low voltage memory

• 2666 MHz SO-DIMMs

• Non-ECC

Find compatible memory modules in the Intel Product Compatibility Tool

• NUC10i7FNH

• NUC10i5FNH

• NUC10i3FNH

NOTE

If you plan to install only one memory module, install it in the lower memory
socket.