Page 1
TOTAL SPEAKER SOLUTIONS
TSS-4000
TSS-STAND4000
Owner’s Guide
Page 2
Installing the TSS-SAT4000
Step One
Remove the bottom end cap of the speaker by unscrewing the
single center screw (Allen wrench included with satellite).
Satellite Speaker
Infinity Logo
End Cap
NOTE:The bottom is the side
closest to the Infinity logo on
the front grille.
1/4-20 x 3/4" Screw
Step Three
Align and insert the alignment pin into the bottom of the speaker.
Step Two
Attach alignment pin to stand, and run speaker wire up stand.
NOTE: Needle-nose pliers may be required.
Alignment Pin
Alignment Pin
Page 3
Step Four
Tighten the bolts on the bottom as shown. It’s recommended that
two people perform this step so that the speaker is supported
s on its side and the bolts are being tightened.Attach
while it’
speaker wire as described in TSS-SAT4000 Owner’s Manual.
47-1/2"
Bolts
25"
Page 4
© 2004 Harman International Industries,Incorporated
Infinity Systems,250 Crossways Park Drive, Woodbury, NY 11797 USA 516.674.4INF (USA only) www.infinitysystems.com
Infinity is a registered trademark,and Total Solutions is a trademark,of Harman International Industries, Incorporated. Part No. 400-OMSTN 10/04
Loading...