hank you for choosing Humminbird®, the #1 name in marine electronics. Humminbird has built its reputation by designing and
T
anufacturing top quality, thoroughly reliable marine equipment. Your Humminbird is designed for trouble-free use in even the
m
arshest marine environment. We encourage you to read this manual carefully in order to get the full benefit from all the features
h
nd applications of your Humminbird product.
a
Contact Humminbird Customer Service at humminbird.com or call 1-800-633-1468.
WARNING! This device should not be used as a navigational
aid to prevent collision, grounding, boat damage, or
personal injury. When the boat is moving, water depth may
change too quickly to allow time for you to react. Always
perate the boat at very slow speeds if you suspect shallow
o
water or submerged objects.
WARNING! The electronic chart in your Humminbird unit is
an aid to navigation designed to facilitate the use of
authorized government charts, not to replace them. Only
official government charts and notices to mariners contain
all of the current information needed for the safety of
navigation, and the captain is responsible for their prudent
use.
WARNING! Disassembly and repair of this electronic unit
should only be performed by authorized service personnel.
Any modification of the serial number or attempt to repair
the original equipment or accessories by unauthorized
individuals will void the warranty.
WARNING! This product contains chemicals known to the
State of California to cause cancer and birth defects or
reproductive harm.
WARNING! Humminbird is not responsible for the loss of data
files (waypoints, routes, tracks, groups, recordings, etc.) that
may occur due to direct or indirect damage to the unit’s
hardware or software. It is important to back up your control
head’s data files periodically. Data files should also be saved
to your PC before restoring the unit’s defaults or updating
the software. See your Humminbird online account at
humminbird.com, the Waypoint Management Guide, and your
control head operations guide for details.
NOTE: Some features discussed in this manual require a
separate purchase, and some features are only available on
international models. Every effort has been made to clearly
identify those features. Please read the manual carefully in
rder to understand the full capabilities of your model.
o
NOTE: The Ethernet accessory is compatible with many
Humminbird models, and every effort has been made to note the
differences between the models and functions throughout this
manual. The illustrations in this manual may look different than
your display, but your model will operate in a similar way.
NOTE: To purchase accessories for your control head, visit our
Web site at humminbird.com or contact Humminbird Customer
Service at 1-800-633-1468.
NOTE: The procedures and features described in this manual are
subject to change without notice. This manual was written in
English and may have been translated to another language.
Humminbird is not responsible for incorrect translations or
discrepancies between documents.
NOTE: Product specifications and features are subject to change
without notice.
NOTE: Humminbird verifies maximum stated depth in saltwater
conditions, however actual depth performance may vary due to
transducer installation, water type, thermal layers, bottom
composition, and slope.
ROHS STATEMENT: Product designed and intended as a fixed
installation or part of a system in a vessel may be considered beyond
the scope of Directive 2002/95/EC of the European Parliament and of
the Council of 27 January 2003 on the restriction of the use of certain
hazardous substances in electrical and electronic equipment.
ATTENTION INTERNATIONAL CUSTOMERS: Products sold in the U.S.
are not intended for use in the international market. Humminbird
international units provide international features and are designed
to meet country and regional regulations. Languages, maps, time
zones, units of measurement, and warranty are examples of
features that are customized for Humminbird international units
purchased through our authorized international distributors.
To obtain a list of authorized international distributors, please visit
our Web site at humminbird.com or contact Humminbird Customer
Service at (334) 687-6613.
2
ENVIRONMENTAL COMPLIANCE STATEMENT: It is the intention of Johnson Outdoors Marine Electronics, Inc. to be a responsible corporate citizen,
operating in compliance with known and applicable environmental regulations, and a good neighbor in the communities where we make or sell
our products.
WEEE DIRECTIVE: EU Directive 2002/96/EC “Waste of Electrical and Electronic Equipment Directive (WEEE)” impacts most distributors, sellers,
and manufacturers of consumer electronics in the European Union. The WEEE Directive requires the producer of consumer electronics to take
esponsibility for the management of waste from their products to achieve environmentally responsible disposal during the product life cycle.
r
WEEE compliance may not be required in your location for electrical & electronic equipment (EEE), nor may it be required for EEE designed and
intended as fixed or temporary installation in transportation vehicles such as automobiles, aircraft, and boats. In some European Union member
states, these vehicles are considered outside of the scope of the Directive, and EEE for those applications can be considered excluded from the
WEEE Directive requirement.
This symbol (WEEE wheelie bin) on product indicates the product must not be disposed of with other household refuse. It must be disposed
of and collected for recycling and recovery of waste EEE. Johnson Outdoors Marine Electronics, Inc. will mark all EEE products in accordance
with the WEEE Directive. It is our goal to comply in the collection, treatment, recovery, and environmentally sound disposal of those
products; however, these requirements do vary within European Union member states. For more information about where you should
ispose of your waste equipment for recycling and recovery and/or your European Union member state requirements, please contact your dealer
d
or distributor from which your product was purchased.
360 Imaging®, 700 Series™, 800 Series™, 900 Series™, 1100 Series™, Down Imaging®, DualBeam PLUS™, Fish ID+™, HELIX™, Humminbird®, InterLink™, RTS Window™,
Side Imaging®, SwitchFire®, WhiteLine™, and X-Press™ Menu are trademarked by or registered trademarks of Johnson Outdoors Marine Electronics, Inc.
his manual will guide you through the following network setup instructions:
T
1. Connect two Humminbird units together
2. Power On
3. Configure your Humminbird Ethernet Network
4. Share Waypoints
Alarms, navigation, sonar data, and the menu system are all affected by the Ethernet network settings. We encourage
you to read this manual completely so that you may understand the full capabilities of your Humminbird Ethernet
network.
7
Introduction
1. INSTALL AN ETHERNET CONNECTION
If your Humminbird control head has a built-in Ethernet connector, the unit can be connected to the Ethernet network. When you
connect the units together, data is shared between the two units.
Before you start, please note that the Ethernet network installation has the following requirements:
pdate Software: Your model may require a software update to enable Ethernet. Log in to your account at humminbird.com
• U
to download the latest software update. For assistance, contact Customer Service.
• Install the control heads and sources (GPS, transducers, temp/speed accessories, etc.) for your Fishing System. See the
equipment installation guides for details.
• Purchase Ethernet Connection Cables (separate purchase required): Your network configuration and Ethernet port shape will
determine which Humminbird connection cables you will need to purchase.
Purchase Ethernet Cables and Equipment
1. Review the illustrations on the following pages. Find your control head models and locate the Ethernet port on each control
head.
The shape of the Ethernet port determines the cable(s) you need to purchase, as shown in the following table. The Ethernet
port will be round or shaped like an hourglass.
Ethernet Cable Information
Control HeadsRequired Cables
(2) Units with Hourglass-shaped Ethernet Ports(2) AS EC QDE & (1) AS EC [length]E
(1) Unit with an Hourglass-Shaped Port and (1) Unit
with a Round Ethernet Port
(2) Units with Round Ethernet Ports(1) AS EC [length]E
NOTE: The AS EC [length]E cable is available in a variety of lengths. To purchase the Ethernet Cables and extension cables, visit
our Web site at humminbird.com. To network more than two units, purchase the Humminbird AS ETH 5PXG.
(1) AS EC QDE & (1) AS EC [length]E
Installation
8
100ci Series HD Control Head with Hourglass-shaped Ethernet Port
1
100c Series Control Head with Round Ethernet Port
1
Ethernet port
800ci Series/900ci Series HD Control Head
with Hourglass-shaped Ethernet Port
Ethernet port
700 Series HD Cable Collector with
Hourglass-shaped Ethernet Port
Ethernet port
800c Series/900c Series Control Head with Round Ethernet Port
Ethernet port
HELIX 9, 10, 12 (Cable Tray) with
Hourglass-shaped Ethernet Port
Ethernet
Ethernet
9
Installation
Connect the Control Heads
. Confirm that the control heads are powered off.
1
2. Review the illustrations on the preceding pages. Find your control head models and locate the Ethernet port on each control
head.
3. Connect the Ethernet cable(s) together and route them to each control head. Connect the Ethernet cable(s) to each Ethernet
port, noting the following:
• The connectors are keyed to prevent incorrect installation, so be careful not to force the connectors into the port.
• On round cable connectors, hand-tighten the screw nut to secure the connection.
• If the control head has a round Ethernet port, the Ethernet cable can be connected directly to the control head. If the control
head has an hourglass-shaped port, it will connect to the unit through a cable collector or cable tray. Consult your control
head installation guide for details.
CAUTION! Do NOT mount the cables where the connectors could be submerged in water or flooded. If cables are installed in a
splash-prone area, it may be helpful to apply dielectric grease to the inside of the connectors to prevent corrosion. Dielectric
grease can be purchased separately from a general hardware or automotive store.
HELIX 9, 10, 12 (Cable Tray) with
Hourglass-shaped Ethernet Port
Ethernet
Connecting the Cable Tray to the Control Head (HELIX 9, 10, 12)
line up with pins
on cable tray
clasp
Humminbird
logo facing up
Installation
10
onnecting to a Round Ethernet Port
E
C
Ethernet port
Hand-Tightening the Screw Nut
screw nut
The connector is keyed to
prevent incorrect installation.
AS EC (length)E
700 Series HD Quick Disconnect
Mount Cable Collector
Ethernet
Connecting the Ethernet Cables to a 700 Series HD Unit
Ethernet port
Cable Collector
AS EC QDE Ethernet
Adapter Cable
AS EC(length)E
round
connectors
11
Installation
Loading...
+ 23 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.