HP PSC 2500 Setup Poster [ar]

1010

1111

Macintosh Direct Connect (USB) setup poster

Macintosh Direct Connect START HEREMacintosh Direct Connect START HERE

This side of the poster covers Macintosh direct connect setup. See reverse side for Windows.

Network setup is covered on the other poster. Make sure you use the correct poster and CD.

Attach front panel cover

Load paper

Connect phone cord

Turn HP device on and configure

Insert print cartridges

Connect power cords

Install software

Align print cartridges

Congratulations!

Lift the print carriage door up until it catches. Lift the blue and gray latches.

Remove the bright pink tape from both print cartridges. Do not touch the gold-colored contacts or retape the cartridges.

Press OK on the front panel to begin alignment. After a page prints, alignment is complete. Discard or recycle this page.

Make sure both latches are locked into position. Close the door.

Turn on your Macintosh and wait for it to finish starting up. Insert the HP PSC Macintosh CD.

Double-click the HP All- In-One Installer icon on your desktop.

Follow the onscreen instruction. Make sure you complete the Setup Assistant.

Use blank white paper to prepare for print alignment.

You are ready to begin using your HP PSC. See the Reference Guide to get started.

Remove any packaging material.

Place the front panel cover over the buttons. Firmly press on the sides to snap the cover in place. Make sure all the buttons are visible.

Lift the display.

a b

Connect USB cable

Press down on the gray latch until it locks into place. Insert the color cartridge on the left side, and lock into place.

Turn power on.

Select your language, and then press OK. Select your country/region, and then press OK.

Do not connect the USB cable to a keyboard.

You must connect the supplied phone cord to the phone jack on the left (1-LINE).

To connect an answering machine or use your own phone cord, see the Fax Setup chapter in the

Reference Guide.

1-LINE

hp psc 2500 photosmart series all-in-one

Hold the black print cartridge with the label on top as shown. Slide the cartridge underneath the metal bar into the right (gray latch) side of the print carriage.