HP ProLiant DL360p G6 DVD-ROM and DVD-RW Drive Option Installation Instructions
DVD-ROM and DVD-RW Drive
Option
Installation Instructions
for HP ProLiant DL360 G6 Servers
Overview
This document provides instructions for installing a SATA DVD-ROM or
DVD-RW drive. When you install this drive, the server does not support
the additional hard drive backplane.
Kit contents
• DVD-ROM or DVD-RW drive
• DVD tray
• T-10 screws (3)
• SATA optical drive cable
• This document
Installing the DVD-ROM or
DVD-RW drive
1. Power down the server, and then disconnect all power cords to
remove power from the server.
2. Extend the server from the rack.
3. Remove the access panel.
4. Remove the dual hard drive bezel blank.
5. Install the optical drive in the DVD tray.
6. Secure the drive to the tray using the screw from this kit and the
T-10/T-15 Torx screwdriver provided with the server.
7. Install the DVD tray using the screws from this kit and the
T-10/T-15 Torx screwdriver provided with the server.
8. Remove the BBWC battery, if installed.
© Copyright 2009, 2012 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for
HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein. Bluetooth is a
trademark owned by its proprietor and used by Hewlett-Packard Company
under license.
Part Number: 517695-002
March 2012
Edition: 2
9. Remove the air baffle.
10. Remove fan modules 3 and 4.
11. Connect the SATA optical drive cable to the rear of the drive.
12. Route the SATA optical drive cable along the edge of the system
board, and then connect the cable to the system board.
13. Install fan modules 3 and 4.
14. Install the air baffle.
15. Install the BBWC battery, if removed.
16. Install the access panel.
17. Slide the server into the rack.
18. Connect all power cords to the server, and then power up the
server.
The installation is complete.
European Union regulatory notice
Products bearing the CE marking comply with the following EU
Directives:
• Low Voltage Directive 2006/95/EC
• EMC Directive 2004/108/EC
• Ecodesign Directive 2009/125/EC, where applicable
CE compliance of this product is valid if powered with the correct
CE-marked AC adapter provided by HP.
Compliance with these directives implies conformity to applicable
harmonized European standards (European Norms) that are listed in
the EU Declaration of Conformity issued by HP for this product or
product family and available (in English only) either within the product
documentation or at the following HP website
(http://www.hp.eu/certificates) (type the product number in the
search field).
The compliance is indicated by one of the following conformity
markings placed on the product:
For non-telecommunications products and for EU harmonized
telecommunications products, such as Bluetooth® within power class
below 10mW.
For EU non-harmonized telecommunications products (If applicable, a
4-digit notified body number is inserted between CE and !).
Please refer to the regulatory label provided on the product.
The point of contact for regulatory matters is Hewlett-Packard GmbH,
Dept./MS: HQ-TRE, Herrenberger Strasse 140, 71034 Boeblingen,
GERMANY.
Korean class B notice
Loading...