Hp OMNIBOOK 5000 Getting Started

HP OmniBook
Getting Started
Notice
This manual and any examples contained herein are provided “as is” and are subject to change without notice. Hewlett-Packard Company makes no warranty
of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
Consumer transactions in Australia and the United Kingdom: The above disclaimers and limitations shall not apply to Consumer transactions in Australia and the United Kingdom and shall not affect the statutory rights of Consumers.
© Copyright Hewlett-Packard Company 1995-96. All rights reserved. Reproduction, adaptation, or translation of this manual is prohibited without prior written permission of Hewlett-Packard Company, except as allowed under the copyright laws.
The programs that control this product are copyrighted and all rights are reserved. Reproduction, adaptation, or translation of those programs without prior written permission of Hewlett-Packard Co. is also prohibited.
Portions of the programs that control this product may also be copyrighted by Microsoft Corporation, SystemSoft Corp., and Chips and Technologies, Inc. See the individual programs for additional copyright notices.
Microsoft, DriveSpace, MS, MS-DOS, and Windows are registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries (U.S. patent numbers 4955066 and 4974159). SystemSoft is a registered trademark and CardWizard, CardLite, and CardID are trademarks of SystemSoft Corporation.
For warranty and regulatory information, see the Support and Service booklet.
Hewlett-Packard Company Mobile Computing Division 1000 N.E. Circle Blvd. Corvallis, OR 97330, U.S.A.
ii
HP Software Product License Agreement
The HP Software Product License Agreement and Product Limited Warranty shall govern all Software which is provided to you, the Customer, as part of the HP computer product. The HP Software Product License Agreement and Product Limited Warranty shall supersede any non-HP software license or non-HP warranty terms which may be found in any documentation or other materials contained in the computer product packaging.
Carefully read this License Agreement before proceeding to operate this equipment. Rights in the software are offered only on the condition that the Customer agrees to all terms and conditions of the License Agreement. Proceeding to operate the equipment indicates your acceptance of these terms and conditions. If you do not agree to the License Agreement, you must now either remove the software from your hard disk drive and destroy the master diskettes, or return the complete computer and software for a full refund.
Software License Agreement
In return for payment of the applicable fee, Hewlett-Packard grants the Customer a license in the software, subject to the following:
1. Use. Customer may use the software on any one computer. Customer may not
network the software or otherwise use it on more than one computer. Customer may not reverse assemble or decompile the software unless authorized by law.
2. Copies and Adaptations. Customer may make copies or adaptations of the
software (a) for archival purposes or (b) when copying or adaptation is an essential step in the use of the software with a computer so long as the copies and adaptations are used in no other manner.
3. Ownership. Customer agrees that he/she does not have any title or ownership
of the software, other than ownership of the physical media. Customer acknowledges and agrees that the software is copyrighted and protected under the copyright laws. Customer acknowledges and agrees that the software may have been developed by a third party software supplier named in the copyright notices included with the software, who shall be authorized to hold the Customer responsible for any copyright infringement or violation of this Agreement.
iii
4. Transfer of Rights in Software. Customer may transfer rights in the software
to a third party only as part of the transfer of all rights and only if Customer obtains the prior agreement of the third party to be bound by the terms of this License Agreement. Upon such a transfer, Customer agrees that his/her rights in the software are terminated and that he/she will either destroy his/her copies and adaptations or deliver them to the third party.
5. Sublicensing and Distribution. Customer may not lease, sublicense the
software or distribute copies or adaptations of the software to the public in physical media or by telecommunication without the prior written consent of Hewlett-Packard.
6. Termination. Hewlett-Packard may terminate this software license for failure
to comply with any of these terms provided Hewlett-Packard has requested Customer to cure the failure and Customer has failed to do so within thirty (30) days of such notice.
7. Updates and Upgrades. Customer agrees that the software does not include
updates and upgrades which may be available from Hewlett-Packard under a separate support agreement.
8. Export Clause. Customer agrees not to export or re-export the software or any
copy or adaptation in violation of the U.S. Export Administration regulations or other applicable regulation.
9. U.S. Government Restricted Rights. Use, duplication, or disclosure by the
U.S. Government is subject to restrictions as set forth in subparagraph (c)(1)(ii) of the Rights in Technical Data and Computer Software clause in DFARS
252.227-7013. Hewlett-Packard Company, 3000 Hanover Street, Palo Alto, CA 94304 U.S.A. Rights for non-DOD U.S. Government Departments and Agencies are as set forth in FAR 52.227-19(c)(1,2).
Edition History
Edition 1 ........................................ September 1995
Edition 2 ........................................... March 1996
This manual is printed on recycled paper.
iv
Contents
1 Starting Out with Your OmniBook
Start Here ........................................... 1-3
1. Insert the battery ................................... 1-3
2. Connect the ac adapter .............................. 1-4
3. Reset the OmniBook ................................ 1-5
4. Open the OmniBook ................................ 1-5
5. Turn on the OmniBook .............................. 1-6
6. Go through the setup screens .......................... 1-7
Where to go from here ................................ 1-7
2 Troubleshooting
Solving Basic Problems .................................. 2-3
3 Specifications and Regulatory Information
Hardware Specifications ................................. 3-3
Regulatory Information .................................. 3-4
U.S.A. ............................................ 3-4
Canada ........................................... 3-5
Japan ............................................ 3-5
Europe ........................................... 3-6
Contents
1
Starting Out with Your OmniBook
Starting Out with Your OmniBook
Congratulations! Your OmniBook sets a new standard in personal computing. Although it's compact, the OmniBook is equipped with a full-size keyboard and standard Microsoft Windows—all loaded and ready to go. What's more, your OmniBook has been specifically designed for ease of use on the road. It features "instant-on" power that immediately restores your last session. And the OmniBook is infused with the quality and attention to detail that are the hallmark of Hewlett­Packard.
This OmniBook Getting Started manual shows how to get your OmniBook up and running quickly. It also shows what to do if you run into trouble getting it started.
About Your OmniBook Manuals
Your OmniBook provides these manuals—convenient, yet portable sources of extensive information about your OmniBook and its preinstalled software:
The online Quick Start Guide gives you a fun and easy introduction to the
OmniBook. In Windows for Workgroups, look in Program Manager in the OmniBook Library group. In Windows 95, look in Start, Programs, OmniBook Library.
The online OmniBook User's Guide introduces the OmniBook and shows you
how to operate and maintain your OmniBook. It also contains thorough troubleshooting information. In Windows for Workgroups, look in Program Manager in the OmniBook Library group. In Windows 95, look in Start, Programs, OmniBook Library.
For Windows for Workgroups, the online Windows Quick Start and MS-DOS
Quick Start manuals contain information about Windows for Workgroups and
MS-DOS. Look in Program Manager in the OmniBook Library group.
For Windows 95, the printed Introducing Microsoft Windows manual and the
online Using Windows 95 manual contain information about Windows 95. Look in Start, Programs, OmniBook Library for the online manual.
1-2
Starting Out with Your OmniBook
Start Here
Start Here
To start using your OmniBook the first time, you have to make the following preparations—they’re described in detail on the following pages:
1. Insert the battery, if it’s not already inserted.
2. Connect the ac adapter. (The battery isn’t charged yet.)
3. Press the reset button. (You should only have to do this the first time you start the OmniBook.)
4. Open the OmniBook.
5. Turn on the OmniBook.
6. Go through the setup screens.
7. Begin working!
1. Insert the battery
1. For easiest access to the battery, close the display and turn your computer over.
2. Slide the battery module into the empty bay. Carefully press the battery all the way into the compartment. You will hear a click as the locking switches move outward and the module is locked in place.
1-3
Loading...
+ 18 hidden pages