yrig
g
UV100E Ultraviolet
Air Treatment System
OWNER’S GUIDE
® U.S. Registered Trademark
Cop
ht © 2001 Honeywell Inc.
hts Reserved
All Ri
69- 1442- 1
UV100E ULTRAVIOLET AIR TREATMENT SYSTEM
g
q
g
y
y
y
y
g
g
y
y
y
y
g
HOW YOUR ULTRAVIOLET AIR TREATMENT SYSTEM WORKS
When installed in forced air heating and cooling systems, your UV100E Ultraviolet Air
Treatment System kills a high percentage of micro-organism contaminants in the air
passin
maintenance re
delivery fan operates.
over it. Individual results depend on how carefully all installation and
uirements are followed and on the actual amount of time your air
You can capture and minimize micro-or
ventilation and air conditioning (HVAC) system when you combine your Ultraviolet Air
Treatment S
air cleaner. Talk to
our air treatment system and provide added protection for you and your family.
Your UV100E Ultraviolet Air Treatment S
a single-lamp, moderate-efficiency return air unit; a dual-lamp,
h-efficiency return air unit; or an air conditioner coil irradiation unit.
hi
• The UV100E1001 sin
stem. It has moderate-efficiency performance in reducing airborne bacteria in
s
return air s
• The UV100E1019 dual-lamp unit is mounted in your return air duct of your HVAC
stem. It has high-efficiency performance in reducing airborne bacteria in return air
s
stems.
s
• The UV100E1035 coil irradiation unit is mounted in your supply side air duct or
downstream from the air conditioner coolin
lamp reduces mold and spores on duct surfaces, coils and drain pans.
stem with a high-efficiency air filtration system that includes an electronic
our installer about adding an electronic air cleaner to complement
le-lamp unit is mounted in the return air duct of your HVAC
stems.
anism pass-through in your heating,
stem unit is one of these three models:
coils in your HVAC system. The single
69-1442-1 2
UV100E ULTRAVIOLET AIR TREATMENT SYSTEM
y
y
y
y
y
g
y
y
HOW YOU CAN CHECK YOUR ULTRAVIOLET AIR TREATMENT SYSTEM OPERATION
WARNING
UV Light Hazard.
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision.
Never look at the lamps while illuminated.
view illumination by way of the light indicator located on the lamp knob.
Onl
To prevent exposure to ultraviolet light, disconnect power to the ultraviolet air
treatment s
stem.
s
Do not mount device in location that allows ultraviolet light to be seen after
installation.
Do not attempt to b
Do not attempt to open housing; unit is sealed to prevent ultraviolet light
exposure.
stem before servicing any part of the heating/air conditioning
pass the duct mount switch.
Your Ultraviolet Air Treatment S
electrical outlet. Your unit is desi
and with the ultraviolet ra
unless the base is mounted on the HVAC duct.
It is recommended that ever
operating
attempt to look into the duct at the illuminated lamp(s).
only by viewing through the lamp light indicator on the lamp knob. Do not
stem has a power cord that plugs into a 120 Vac
ned to prevent accidental contact with the voltage
s in the sealed unitthe ultraviolet lamps do not illuminate
month you verify that your ultraviolet lamp(s) are
3 69-1442-1
UV100E ULTRAVIOLET AIR TREATMENT SYSTEM
y
g
g
y
(
y
y
g
g
HOW YOU CAN MAINTAIN YOUR ULTRAVIOLET AIR TREATMENT SYSTEM
Your should regularly clean your ultraviolet lamps to maintain your air treatment
system. And once every year, you must remember to replace your ultraviolet lamps.
CAUTION
Personal Injury Hazard.
Power supply can cause electrical shock.
Disconnect power suppl
Do not open base unit or lamp knob; there are no user-serviceable
components inside.
before cleaning or replacing ultraviolet lamp(s).
CAUTION
Breakable Glass Hazard.
Can cause personal injury.
Be careful when insertin
Wear protective
loves when handling lamp(s).
Cleaning Your Lamps Every Three Months (Quarterly)
lamp(s) into lamp base.
MERCURY NOTICE
This device contains mercury in the sealed ultraviolet lamp(s). Do not place
our used lamp(s) in the trash. Dispose of properly.
Broken Lamp Cleanup.
Do not use a household vacuum.
Sweep debris
Contact
cling and the proper disposal of old lamp(s). If you have questions, call
rec
Honeywell Customer Assistance at 1-800-468-1502.
Lamp cleanin
three months (quarterly). Use the Ultraviolet Lamp Cleaning Reminder Schedule,
. 1, to help you establish and track your regular cleaning schedule.
Fi
69-1442-1 4
is recommended as routine maintenance four times a year or every
phosphor/glass) into a plastic bag and dispose of properly.
our local waste management authority for instructions regarding
UV100E ULTRAVIOLET AIR TREATMENT SYSTEM
g
)
y
g y
y
(s)
y
g
UV LAMP CLEANING REMINDER SCHEDULE
INSTALLATION DATE: (month)
YEAR
JFMAMJJASOND
Fig. 1. Ultraviolet lamp cleaning reminder schedule.
, (year)
M13516
CAUTION
UV Lamp Burn Hazard.
Harmful to bare skin.
Can cause severe burns.
Disconnect power 15 minutes before removin
IMPORTANT
If the lamps in your model have external wires running along the glass
surface, be sure to avoid pulling on those wires.
To clean your lamps:
1.
Disconnect the power to
2.
Unplu
our ultraviolet air treatment system cord from the electrical outlet and
our HVAC system.
allow the lamps to cool for at least 15 minutes.
3.
Rotate
remove the lamp
4.
Holding only the lamp knob, wipe the lamp glass using a soft cloth with window
our lamp knob counterclockwise and gently pull the lamp knob to
.
cleaner applied to it. Do not touch the lamp surface with
the cloth.
5.
To ensure that the lamp indicator continues to function, use a moistened cotton
swab to
ently remove any dust that may have collected between the lamp light
indicator on the base and the black lamp base.
5 69-1442-1
the ultraviolet lamp(s
our hands. Use only
UV100E ULTRAVIOLET AIR TREATMENT SYSTEM
y
y
(
y
y
y
g
y
y
g
y
y
g
g
(
6.
Wipe
7.
our lamps with a clean, dry cloth.
our clean lamps back into the unit base by following Replacing Your Lamps
Put
Annually) section steps 5, 6, and 7.
WARNING
UV Light Hazard.
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision.
Never look at the lamps while illuminated.
view illumination by way of the light indicator located on the lamp knob.
Onl
To prevent exposure to ultraviolet light, disconnect power to the ultraviolet air
treatment s
stem.
s
stem before servicing any part of the heating/air conditioning
8.
9.
10.
the cord into the nearby 120 Vac electrical outlet.
Plu
that the ultraviolet lamp(s) are operating
Verif
light indicator on the lamp knob.
illuminated
Reconnect the power to
.
Never look directly at your lamps while
our HVAC system.
only
by viewing through the lamp
CAUTION
UV Lamp Burn Hazard.
Harmful to bare skin.
Can cause severe burns.
Disconnect power 15 minutes before removin
IMPORTANT
If the lamps in your model have external wires running along the glass
surface, be sure to avoid pulling on those wires.
Replacing Your Lamps (Annuall y)
Annual replacement of your lamps is required. To replace your lamps:
1.
Select and obtain the correct replacement lamp for
2.
Disconnect the power to
3.
Unplug your ultraviolet air treatment system cord from the electrical outlet and
allow the lamps to cool for at least 15 minutes.
4.
Rotate the lamp knob counterclockwise and
the lamp(s).
5.
Insert the lamp into the base unit with the lamp li
o’clock position
lamp surface with your hands
left of the raised button on the unit cover).
our HVAC system.
.
the ultraviolet lamp(s).
our unit. See Table 1.
ently pull the lamp knob to remove
ht indicator at the eleven
Do not touch the
69-1442-1 6
UV100E ULTRAVIOLET AIR TREATMENT SYSTEM
g
g
g
y
g
y
g y
y
g
y
(
)
(
)
6.
Continue li
This should cause the lamp to drop into the bottom of the lamp well.
7.
Rotate the lamp clockwise until it snaps into place with the lamp li
ned with the raised button on the unit cover.
ali
htly pushing in on the lamp while rotating it slowly counterclockwise.
WARNING
UV Light Hazard.
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision.
Never look at the lamps while illuminated.
view illumination by way of the light indicator located on the lamp knob.
Onl
To prevent exposure to ultraviolet li
treatment s
system.
8.
Plu
our ultraviolet air treatment system cord into the nearby 120 Vac electrical
outlet.
9.
that your ultraviolet lamp(s) are operating
Verif
lamp li
illuminated
10.
Reconnect the power to
stem before servicing any part of the heating/air conditioning
ht indicator on the lamp knob.
.
our HVAC system.
ht, disconnect power to the ultraviolet air
only by viewing through
Never look directly at your lamp(s) while
ht indicator
the
Table 1. Replacing Your Lamp(s).
Unit Description Replacement Lamps Wattage
UV100E1001 Single-Lamp
Return Air Unit
UV100E1019 Dual-Lamp
Return Air Unit
UV100E1035 Coil Irradiation Unit UC100E1030 36W
UC100E1006 18W
UC100E1014
two lamps required
7 69-1442-1
twin pack
36W
Five-Year Limited Warranty
y
y
y
g
y
g
y
y
y
y
g
g
y g
y
y
y
Honeywell warrants this product, excluding lamps, to be free from defects in the workmanship or
materials, under normal use and service, for a period of five (5) years from the date of purchase
the consumer. If, at any time during the warranty period, the product is defective or
b
malfunctions, Hone
period of time.
If the product is defective,
(i) return it, with a bill of sale or other dated proof of purchase, to the retailer from which
purchased it, or
(ii) packa
description of the malfunction, and mail it, postage prepaid, to the following address:
Hone
Dock 4 MN10-3860
1885 Dou
Golden Valle
This warrant
shown b
Honeywell that the defect or malfunction was caused by damage which occurred while
the product was in the possession of a consumer.
Hone
well’s sole responsibility shall be to repair or replace the product within the terms stated
above. HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND,
INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY
OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR
ANY OTHER FAILURE OF THIS PRODUCT. Some states do not allow the exclusion or limitation
of incidental or consequential dama
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES ON THIS
PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED
TO THE FIVE YEAR DURATION OF THIS WARRANTY. Some states do not allow limitations on
how lon
This warrant
to state.
If
Honeywell, 1985 Douglas Dr N MN10-1461, Golden Valley, MN 55422 or call 1-800-468-1502,
Monda
Hone
an implied warranty lasts, so the above limitation may not apply to you.
ou have any questions concerning this warranty, please write Honeywell Customer Relations,
-Friday, 7:00 a.m. to 5:30 p.m., Central time. In Canada, write Retail Products ON15-02H,
well Limited/Honeywell Limitée, 35 Dynamic Drive, Scarborough, Ontario, M1V4Z9.
well shall repair or replace it (at Honeywell’s option) within a reasonable
ou
e it carefully, along with proof of purchase (including date of purchase) and a short
well Return Goods
las Dr N
, MN 55422
does not cover removal or reinstallation costs. This warranty shall not apply if it is
es, so this limitation may not apply to you.
ives you specific legal rights, and you may have other rights which vary from state
Home and Building Control Home and Building Control
Honeywell Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MN 55422 Scarborough, Ontario
69-1442-1 G.H. 3-01
M1V 4Z9
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.
Loading...