Honeywell T7414A, WPF20A, VF20A PRODUCT DATA

T7414A / VF20A / WPF20A
GENERAL
The T7414A/VF20A/WPF20A Strap-on Temperature Sensors are used for temperature measurement on warm/hot water pipes or solar collectors.
The sensors can be employed for hot and cold water installations in the following control systems
Excel 5000
MicroniK 200
MicroniK 100
Excel Classic
Excel Plus
High Performance Excel Plus
Excel EMC
or other systems using PT1000 or NTC 20k temperature sensing elements.
STRAP-ON
TEMPERATURE SENSORS
PRODUCT DATA
FEATURES
PT1000 or NTC 20k temperature sensing element
Wide sensing range
High accuracy
Models
OS no. description sensing range
T7414A1008
VF20A
WPF20A
Strap-on PT1000 Temperature Sensor
Strap-on NTC20k Temperature Sensor
Two strap-on NTC20k Temperature Sensors
SPECIFICATION
Nominal value
PT1000 1000 Ω at 0 °C NTC20k 20 k at 25 °C
Accuracy
PT1000 IEC751 Class B
0.3 K +0.5% |t| (t in °C) NTC20k 0.3 K at 25 °C
Sensitivity
PT1000 3.85 / K NTC20k -934.5 / K at 25 °C (non-linear)
τ
Response time
Electrical connection
T7414A/VF20A terminals for 2 x 1.5 mm² cable WPF20A terminals for 4 x 1.5 mm² cable
Ambient Limits (wiring box)
Transport and -35...+70 °C (-31...+158 °F) storage temperature Humidity 5…95% r.h., non-condensing
Safety (terminal box)
Protection standard IP54 as per EN60529 (T7414) IP30 (VF20, WPF20) Flame retardant V1 as per UL94, Plastic (PC)
Housing
Dimensions See Fig. 1 on page 2 Weight 100 g
1 minute
0.5
0...+110 °C (+32...+230 °F)
0...+110 °C (+32...+230 °F)
0...+110 °C (+32...+230 °F)
® U.S. Registered Trademark EN0B-0364GE51 R0608 Copyright © 2008 Honeywell Inc. • All rights reserved
T7414A / VF20A / WPF20A STRAP-ON TEMPERATURE SENSORS
DIMENSIONS
50
(1.97)
65
(2.55)
33
(1.3)
max. diameter 110
(4.25)
tightening strap
7 (0.28)
Fig. 1. Dimensions of T7414A / VF20A / WPF20A in mm (inches)
INSTALLATION
wiring run max. length
Sensor to controller 200 m (660 ft)
Offset (at PT1000 sensors, only) due to wire resistance per 10 m of distance from sensor to controller:
type of wire temperature offset PT1000
0.5 mm2 (AWG20) 0.18 °C (0.324 °F)
1.0 mm2 (AWG17) 0.09 °C (0.162 °F)
1.5 mm2 (AWG15) 0.06 °C (0.108 °F)
NOTE: Use shielded wiring in areas with high EMI.
Keep 15 cm (5.9’’) minimum distance between sensor lines and 230 Vac power lines.
case hole diameter
allows Pg9 cable
Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Ecublens, Route du Bois 37, Switzerland by its Authorized Representative:
Automation and Control Solutions
Honeywell GmbH Böblinger Strasse 17 71101 Schönaich / Germany Phone: (49) 7031 63701 Fax: (49) 7031 637493 http://ecc.emea.honeywell.com
Subject to change without notice. Printed in Germany
EN0B-0364GE51 R0608
Loading...