Page 1
Speedy M5410 C1001/L1001
SMALL ON/OFF LINEAR VALVE ACTUATORS
PRODUCT DATA
FEATURES
• Suitable for ON/OFF control without feedback
• Short runtime
• Electronic switch-off in the end position ensures long-
term reliability and saves energy
• Furnished with prewired connection cable
• Simple, standardized valve/actuator coupling – thus,
no tools required for mounting
• Small size allows installation where space is limited
• High resistance to glycol and other chemicals
SPECIFICATIONS
Input voltage
M5410C1001 24 Vac, +20...-20%; 50 Hz
APPLICATION
The Honeywell M5410C1001 and M5410L1001 actuators are
designed specifically to provide ON/OFF control in
conjunction with the V5822/23 and V5832/33 series of small
linear valves (DN15/20), the VSxF/VSxC series (DN15/20/25),
as well as with the V100/V2000 TRV series.
The M5410C1001 and M5410L1001 actuators are suitable for
use in all kinds of fast-acting ON/OFF control systems,
including boiler and solar systems, fan coil units, induction
units, small reheaters, and recoolers as well as for zone
control applications. They are employed in electronic
temperature control systems using hot and/or cold water as
the controlled medium.
They are operated by an SPST signal.
M5410L1001 230 Vac, +10...-15%; 50 Hz
Power consumption
M5410C1001 <8 W during operation
<0.5 W in end position
M5410L1001 <1.8 W during operation
<1.8 W in end position
Input signal
M5410C1001 <10 mA
M5410L1001 1 mA
Control mode ON/OFF
Stroke 6.5 mm
Runtime (push/pull) approx. 1.8 mm/s and 0.4 mm/s
Stem force 90 N (minimum)
Protection standard IP 54
Insulation class II
Connection cable 1.5 m
Max. cable length See section “Wiring” on pg. 2
Ambient operating limits 0...60 °C
Weight 0.2 kg
Suitable valves V5822/23, V5832/33 (DN15/20)
VSxF/VSxC (DN15/20/25), and
V100/V2000 TRV
® U.S. Registered Trademark EN0B-0357GE51 R1108
Copyright © 2008 Honeywell Inc. • All rights reserved
Page 2
M5410C1001 / M5410L1001 SMALL ON/OFF LINEAR VALVE ACTUATORS
VERSIONS
OS number power supply stroke action at open contact manual operation stem force (min.)
M5410C1001 24 Vac 6.5 mm stem retracts via valve adjustment cap 90 N
M5410L1001 230 Vac 6.5 mm stem retracts via valve adjustment cap 90 N
OPERATION
The actuator movement is produced by a screw spindle
driven in both directions through a set of gears by a d.c.
motor. The motor is switched OFF electronically when the
actuator has built up the closing force. The actuator is fixed to
the valve body by means of a coupling ring requiring no tools
for mounting. The actuator is maintenance-free and furnished
complete with a ready-to-wire connecting cable.
MOUNTING
NOTE: The actuator may be mounted only either beside or
above the valve. Adjust the valve in the proper
position before mounting the actuator.
Remove the adjustment cap before fixing the actuator to the
valve. For easy mounting, ensure that the actuator is in the
"retracted" (factory-supplied) position before fixing the
actuator to the valve body.
The actuator must be mounted by hand. Do not use tools or
additional force, as that could damage the actuator and valve.
DIMENSIONS
81
28
56
70
88
Fig. 1. Dimensions (in mm)
EN0B-0357GE51 R1108
2
Page 3
M5410C1001 / M5410L1001 SMALL ON/OFF LINEAR VALVE ACTUATORS
WIRING
M5410L1001
CAUTION
• Newer models (identified by the subscript "2" at the
end of the model number appearing on the
manufacturer's plate, e.g. "M5410L1001
protected against miswiring. Incorrect wiring will
damage older models (lacking the subscript "2").
The electrical installation must comply with Fig. 2.
NOTE: The maximum permissible cable length (use 3 x
1.5 mm
2
) between the actuator and the controller is
40 m. If a suppression capacitor (max. 1.5 nF) has
been installed in the line, the max. permissible cable
length is 15 m. Exceeding this limit will result in
actuator malfunction.
NOTE: Older models (lacking the subscript "2") should not
be wired in parallel with newer models (e.g.
"M5410L1001
2"), as the older models will then not
function properly.≤
L
SPST
!
N
2") are
black
brown
blue
M5410C1001
The electrical installation must comply with Fig. 3.
black
brown
SPST
blue
controller
24 Vac
SPST
COM
Fig. 3. Electrical wiring M5410C1001
black
brown
blue
L
N
L
N
controller
black
brown
SPST
controller
max. 1.5 nF
SPST
blue
max. 40 m
black
brown
blue
max. 15 m
Fig. 2. Electrical wiring M5410L1001
3
EN0B-0357GE51 R1108
Page 4
M5410C1001 / M5410L1001 SMALL ON/OFF LINEAR VALVE ACTUATORS
ACTION
Closing the contact at the brown cable will drive the actuator
to the "extended" position. Upon opening the contact, the
actuator will drive back to the "retracted" position.
Fig. 4. Action
Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Rolle, Z.A. La Pièce 16, Switzerland by its Authorized Representative:
Automation and Control Solutions
Honeywell GmbH
Böblinger Strasse 17
71101 Schönaich / Germany
Phone: (49) 7031 63701
Fax: (49) 7031 637493
http://ecc.emea.honeywell.com
Subject to change without notice. Printed in Germany
EN0B-357GE51 R1108
Loading...